Blue Ox Base Plate Installation - 2010 Ford Focus
Alright, today on this 2010 Ford Focus, were going to install part number BX2199 from Blue Ox. To start our install, we got to remove the front bumper cover, starting with these four pushpins right here. Alright, now we can remove the grill assembly. Okay, to remove the grill, you have to pull it straight out. We start from the end and work our way towards the center. Next, remove the headlights, one, two, three fasteners.
Roadmaster Tow Bar Wiring Kit Installation - 2010 Ford Focus
Alright, today on this 2010 Ford Focus, were going to install part number RM-154 from Road Master. Were also using a four way connector for the end of our wire harness and thats the part number PK11410. Okay, to begin our install, were actually going to cut off the wire harness in here at the fourth pole since we were changing over to a round four pole. And the harness has it on both ends, so were going to do both of them. Cut the other end and then we run it to the back. And then well go ahead and figure out a route for our wire harness and run it to the back of the car.
Yakima FrontLoader Roof Bike Rack Review - 2010 Ford Focus
Alright today on this 2010 Ford Focus, we are going to do a test fit the Yakima Bike Rack, part number y02103, this is our front loader. Okay we have this car equipped with the Yakima Roof Rack System already installed. We will go ahead and install the bike rack on top of the crossbars. We will do our first attachment point on the front cross rail, and then we will slide the rear catching point onto the back of the cross rail, and then we will go ahead and tighten them down. The front attachment has a knob in the front that you could twist and it clamps into place, and on the back it has a similar procedure as well. Next well go ahead and loosen up the rear strap, make sure it is out of the way, and then we will make sure that the front wheel holder is in its appropriate spots.
