customer service | view cart  View Cart

2010 Chevrolet Suburban Accessories

change vehicle

Popular Chevrolet Suburban Accessories





2010 Chevrolet Suburban Videos

Thule Crossroad Roof Rack Installation - 2010 Chevy Suburban

In this video we are going to show you how to install a Thule Crossroad roof rack onto a Suburban with existing side rails. We will be using the Thule Crossroad feet, part number TH450, and Thules 58 inch load bars, part number THLB58. The Crossroad pack comes with four Crossroad feet, the end caps with the built in Allen key and four smaller end caps that will go on the end of our bars. The Crossroad feet are designed to quickly and easily attach to the factory side rails on your vehicle. The band is actually a steel band coated in rubber. This gives it plenty of strength but the rubber also protects your factory side rails. It is going to loop around your side rail and connect back to the foot. Then we will use the end cap with the built in Allen head wrench to tighten down this bolt. It will tighten the whole system down to your vehicle, as well as tighten down the crossbars in the foot. 0:55





2010 Chevrolet Suburban Questions and Answers


  • Using a Weight Distribution System on a Boat Trailer With Surge Brakes
  • I contacted Venture Trailers Inc. and found that the reason they do not recommend the use of a weight distribution system is because most weight distribution systems are not recommended for trailers with surge brakes because they do not allow the coupler to push into the coupler housing and engaging the brakes. Also due to the fact that they do apply additional stress on the tongue of the trailer like you said and this can be particularly harmful to aluminum frame trailers. There are some we
    view full answer...

  • Adapting a 7-Way Trailer Connector on a 2010 Chevy Suburban to a 6-Way Square Jayco Connector
  • I do have a solution for you but it a little unorthodox. First, you will need to use a 7-Way to 4-Way adapter like # PK12716. With the 7-Way now converter down to a 4-way, you can use the 4-Way to 6-Way Jayco adapter, # 30104. To make it more like one large adapter, you can use dielectric grease, # 11755, between the 4-Way connections on the 2 adapters and then use electrical tape to wrap up where the two are joined at the 4-Ways. This will only give you the basic lighting functions on th
    view full answer...

  • Will the Thule Rapid Aero Crossroads Foot Pack Fit a 2010 Chevy Suburban
  • As long as your 2010 Chevy Suburban has factory side rails that run front to back, you can use the Thule Rapid Aero Crossroads, # TH450R. You will also need load bars, # THARB53. I have included a link to a video showing installation of this kit for you to view. If your Suburban has factory tracks that run front to back, you will need a different roof rack system using the following parts: Crossbars, # Y00409 Two sets of Landing Pads, # Y00221 Control Towers, # Y00214
    view full answer...

  • Parts Needed to Flat Tow a 2010 Chevy Suburban
  • I will be happy to help you out. First, in order to determine if the 2010 Chevy Suburban model you have can be flat towed, you will need to consult the owners manual. I have found that if you have the 4-wheel drive, automatic transmission model, then it can be flat towed. If you have a 2-wheel drive model with the 4L60E transmission, you will need a transmission lube pump which you can get through Remco. And, if you have the All wheel drive model with the 6L80/90E transmission, it can NOT be
    view full answer...

  • Tire Chain Recommendation for a 2010 Chevy Suburban with 265/70R17 Size Tires
  • We do have many tire chain options for a 265/70-17 tire size. I have included a link to the the tire chains that will fit for you to look at. For a nice set of Thule chains, go for the Self-Tensioning Snow Tire Chains XG12 Pro, # TH01594267, that you have referenced. The chains will tighten and center themselves after you put them on for quick installation. These chains require 12mm of clearance. Consult your vehicle owners manual for specific information on chain usage. I have included li
    view full answer...

  • How Well Do the Locking Mechanisms Stand Up in the Diversi-Tech Aluminum Ball Mounts
  • We have not had any complaints regarding the Self-Locking, Aluminum Ball Mount, # DTALBM6625, locking up or freezing. Sometimes you may need to lift up on or jostle the ball mount to take pressure off of it so it is easier to turn the key. Diversi-Tech recommends using air tool oil in the locking mechanisms to keep it in good working condition. You can check out the customer reviews on the product page. I have also included a link to a video review for you.
    view full answer...

  • Transmission Cooler Recommendation for a 2010 Chevy Suburban with Automatic Transmission
  • According to Derale, you will need the Snap-in Fitting, # D13035. The fitting is used so you will not have to cut and flare lines yourself which can be difficult if you have never done it before. It requires a special tool to flare steel lines so a hose clamp can hold the hose on it. The snap-in simply means that you fit the hose ends over the fitting and the flared ends of it allow a clamp to hold it in place. Given the size of the trailer you want to tow and the terrain being flat, Derale T
    view full answer...

  • Parts Needed to Flat Tow a 2010 Chevy Suburban 1500 4x4 Behind a Motor Home
  • In order to flat tow a vehicle behind your motor home there are 5 things you will need. Base plates for each vehicle being towed, a compatible tow bar, safety cables, lighting on the vehicles being towed, and a supplemental braking system in the vehicle being towed. To find the correct base plates, I need the year of the Dodge Ram 3500. For the 2010 Chevy Suburban, use Roadmaster XL Base Plates, # 3154-1. For a compatible tow bar, I recommend the RoadMaster Blackhawk 2 All Terrain Tow Bar, #
    view full answer...

  • How Much Extension is Gained When Using CIPA Custom Towing Mirror # 10901, 2010 Chevy Suburban
  • I went out to the warehouse and pulled a CIPA Custom Towing Mirror, Driver Side, # 10901, to measure how far the mirror portion is beyond the factory mirror on a 2010 Chevy Suburban. From the edge of the opening where the end of your factory mirror will be to the end of the glass it is 5 inches. To the center of the glass it is about 2-1/2 to 3 inches. So you will get at least that much more extension when using this towing mirror. The passenger side mirror is # 10902.
    view full answer...





Subscribe to email newsletter

Email  

privacy - we don't send unsolicited email




etrailer.com reviews etrailer.com reviews

All images, layout and content copyright etrailer.com