2008 Toyota Sienna Accessories

2008 Toyota Sienna Trailer Hitch

2008 Toyota Sienna Trailer Wiring

2008 Toyota Sienna Base Plate for Tow Bar

2008 Toyota Sienna Roof Rack

2008 Toyota Sienna Trunk Bike Rack

2008 Toyota Sienna Air Filter

2008 Toyota Sienna Suspension Enhancement

2008 Toyota Sienna Transmission Cooler

2008 Toyota Sienna Performance Chip

2008 Toyota Sienna Exterior Lights

2008 Toyota Sienna Tire Chains

2008 Toyota Sienna Floor Mats

2008 Toyota Sienna Vehicle Covers

2008 Toyota Sienna Bug Shield

2008 Toyota Sienna Side Window Vents

2008 Toyota Sienna Lamp Guards

2008 Toyota Sienna Vehicle Tent

2008 Toyota Sienna Vehicle Seat Covers

2008 Toyota Sienna Replacement Mirrors

2008 Toyota Sienna Windshield Wiper Blades

Popular Toyota Sienna Accessories

Toyota Sienna Bike Rack

Toyota Sienna Ball Mounts

Toyota Sienna Cargo Carriers

Toyota Sienna Weight Distribution

Toyota Sienna Locks

Toyota Sienna Cargo Bags

Toyota Sienna Hitch Covers

Toyota Sienna Electronics

Watersport Carriers

Toyota Sienna Vehicle Organizer

Cargo Tie Downs

Toyota Sienna Accessory Step

2008 Toyota Sienna Videos

Trailer Wiring Harness Installation - 2008 Toyota Sienna

Today we are going to install part number 118304 from Tow Ready. On a 2008 on a Toyota Sienna Mini Van. The first thing we are going to do is remove the tail lights. We will start on the passenger side then work our way over to the driver side. To remove the tail light we have to push down on this pin and pull the connector out. We will go ahead and do the same thing for the other side. The next thing we need to do is to remove this trim panel here. There are 3 of these latches we have to remove all the way across from left to right. Once we have those 3 latches removed we can now take off this back part of trim panel. You have to pry it out and lift it up at the same time and it will come loose. Now at this point we need to pull this panel away.

2008 Toyota Sienna Questions and Answers

• Exterior Width of the Powerhouse Battery Box # PH13034
  
• The outside dimensions of the Powerhouse Strap-Style Battery Box # PH13034 that you referenced is 11-1/2 inches long by 8 wide by 8-1/2 inches tall measured at the bottom of the box. The box has a slight taper to it and the width does get slightly wider at the top of the box but that should not matter since you just need the dimensions at the bottom of the box.
  view full answer...


• Using Blue Ox Base Plates to Flat Tow Toyota Sienna with Roadmaster Falcon Tow Bar
  
• In order to use the Blue Ox # BX3757 base plate with your Roadmaster Falcon tow bar, you will need a Roadmaster Tow Bar to Blue Ox Base Plate Adapter, part # RM-031. I have linked you to some flat towing FAQ articles that you might find helpful.
  view full answer...


• Will Curt Class III 2-Inch Hitch # C13105 Fit a 2008 Toyota Sienna Limited
  
• The Curt Class III 2-Inch Hitch, part # C13105, you have referenced, will fit your 2008 Toyota Sienna Limited. If you are meaning an installation DVD on the hitch, I do not offer any installation DVDs. I am including a link to the installation instructions and a link to an installation video of the Curt hitch being installed on a 2006 Sienna. The vehicle is a different year, but it is the same design second generation Sienna as you 2008 model. If you plan on doing some towing, I recommen
  view full answer...


• Which Trailer Hitch Offers the Most Ground Clearance for a 2008 Toyota Sienna LE
  
• The 2008 Toyota Sienna sits low to the ground as it is. Adding any trailer hitch is going to reduce the ground clearance. The hitch that is going to provide the most ground clearance is a Class II hitch from Curt, # C12065. This is only because the receiver and crosstube are smaller (by a fraction of an inch). You may still bottom out on the hitch on inclines like driveways. I have included a link to the installation instructions for you to view. The hitch comes with the correct ball mount, h
  view full answer...


• Class III Trailer Hitch Recommendation for a 2008 Toyota Sienna Van
  
• In my opinion, the Curt hitch, # C13105, is the least obvious once installed on a 2008 Toyota Sienna. This hitch has a cross tube that is designed to flare inward at the ends. The cross tube is also round rather than square with is more aesthetically appealing. I have included a link to a video showing a typical installation of this hitch. I have also linked the instructions. This hitch has a high rating from our customers. If you plan on doing some towing, I recommend the etrailer ball mount
  view full answer...


• Comparing Thule Apex, Vertex, Parkway and Yakima DoubleDown Bike Racks for a 2008 Toyota Sienna
  
• The Thule Apex, # TH9025, and Vertex, # TH9029, are among the newest racks available from Thule and are both solid all around bike racks. The Roadway series of racks is no longer available but the Parkway is, # TH956. This is an older rack that is very popular but is not as advanced as the newer racks. The Yakima DoubleDown, # Y02424, is a lot like the Parkway though it is not as popular and also lacks the design benefits of the newer Thule racks. The Apex and Vertex racks are easier to mo
  view full answer...


• Differences Between Curt Hitch # C13105 and Hidden Hitch # 87415 for a 2008 Toyota Sienna
  
• As far as installation and strength are concerned, the two hitches are actually very similar. Both install in the same location and mounting holes on the vehicle, and both are rated to tow up to 3500lbs. Both hitches will also have a similar ground clearance, because they both would feature the entire cross tube running below the vehicle bumper once installed. The main difference in this case would really be aesthetics. The Curt hitch # C13105 is angled slightly near the ends, so it would
  view full answer...


• Will Thule Big Mouth Roof Mounted Bike Rack, # TH599XTR Fit a 2008 Toyota Sienna with a Roof Rack
  
• In order to use the Thule Big Mouth Roof Mounted Bike Rack, # TH599XTR, with the factory crossbars on your 2008 Toyota Sienna, there is one additional part you will need. Before the bike rack can be attached to the factory bars, you will need Thule Ride-On Adapter, # TH532, because the bike rack is not a direct fit by itself. I have included a link to a video review of the adapter and a link to a video review of the bike rack for you to view.
  view full answer...


• Recommend Ball Mount To Clear Rear Bumper of 2008 Toyota Sienna
  
• We do have a ball mount that should work well for your towing setup, but, the item you referenced, Forged Ball Mount, part # 40332, will not provide the 7 inches of clearance from the pin hole to the edge of the bumper. The item you selected, Titan Ball Mount, part # 45291, cannot be used in the rise position, so it will not work for your towing setup either. A good solution to provide rise to keep your trailer fairly level when towing and to clear your rear bumper would be the Curt Ball
  view full answer...


• Will The Thule CG9 Snow Chains # TH00023104 Fit A 225/60R17 Tire On A 2008 Toyota Sienna AWD
  
• The Thule CG9 Self-Adjusting, Low-Profile Snow Tire Chains for Passenger Vehicles, part # TH00023104, are the correct snow chains for your 2008 Toyota Sienna AWD. They have an internal clearance measurement of 9mm, which will classify them as SAE Class S type snow chains. A SAE Class S snow tire chain means that the minimum sidewall clearance is .59 inches, which is 15mm. If a snow chain has a internal clearance of 15mm or less, they will be classified as a SAE Class S snow chain. The sidewa
  view full answer...


• Fitment of Timbren Rear Suspension Enhancement System on 2008 Toyota Sienna LE AWD
  
• Yes, I contacted our representative at Timbren and she informed me that the product that you selected, the Timbren Rear Suspension Enhancement System, part # TTORSEN04, will fit your 2008 Toyota Sienna LE AWD.
  view full answer...


• Parts needed to Install the Thule Sidekick Roof Rack Cargo Box Part # TH682 on a 2010 Toyota 4Runner
  
• You will only need the Thule Sidekick Roof Mounted Cargo Carrier Box, item # Th682, if your 2010 Toyota 4Runner has the factory roof rack with cross bars that go side to side installed on the vehicle. If you do not have the cross bars from the drivers side to the passengers side you will need the Thule Complete Crossroad Kit with 50 inch Long Bars and Locks, item # TH45058, to complete the roof rack and install the Thule Sidekick.
  view full answer...


• What Wiring Parts are Installed Where on a 2008 Toyota Sienna to Use a Magnetic Towing Light Kit
  
• Since a Toyota Sienna has separate turn and brake signals, you will need a 4-Way harness with a converter. Part # 118304 is the proper 4-Way harness for a 2008 Toyota Sienna. It will plug into the the back of the tail lights, no splicing at all. You will also connect the loose white wire with the eye terminal to a good ground point on the metal body or frame of the vehicle. I have added a link to this part, the instructions for it and a video of the installation. Once you have this part inst
  view full answer...


• What is the Square Bracket on the # 87415 Hitch Cross Tube Used For
  
• The square platform to the left of the ball receiver on the Hidden Hitch Class III Trailer Hitch, item # 87415, is a mounting plate for mounting electrical connectors. You can use any of the mounting brackets that we have available (see link) with this mounting platform to secure the vehicle trailer wiring at the rear of the vehicle.
  view full answer...