customer service | view cart  View Cart

2006 Nissan Pathfinder Accessories

change vehicle

Popular Nissan Pathfinder Accessories





2006 Nissan Pathfinder Questions and Answers


  • Can the Swagman XP Bike Rack be Used on a 2006 Nissan Pathfinder
  • The Swagman XP # S64940 that you referenced can definitely be used on vehicles. The RV rating that you see on this rack is related to the fact that is built strong enough to handle the rougher ride that RVs have when compared to passenger vehicles. If you check out the picture I attached you will see this rack being used on a similar Pathfinder as your 2006 model.
    view full answer...

  • 12 Volt Warning Lights Stays on After Install 4 to 7-Way Converter on a 2006 Nissan Pathfinder
  • First we need to determine why that light is coming on in the first place. If it is coming on after you have installed adapter # C57674 then there is either a draw on the circuit or the vehicle thinks there is. Normally this is caused by a dirty trailer connector or corrosion but since it is a new installation that does not seem likely. The 12 volt power wire (black) is supposed to be installed via a 40 amp circuit breaker, # PK54540. If connected directly to the battery, that may be an issu
    view full answer...

  • Parts Needed to Add a 7-Way Trailer Connector to a 2006 Nissan Pathfinder with Factory Tow Package
  • If the trailer you are towing has a 7-Way but does not have electric brakes, reverse lights, or require 12 volt power then I wonder why it has a 7-Way on it unless it is just for a battery. But to add a 7-Way to your 2006 Nissan Pathfinder you can use the adapter # C57674. Your 4-Way will plug in to the 4-Way end on the adapter. You are correct about the white wire on the adpater. It will need to be grounded to the vehicle frame. The remaining wires are black for 12 volt power, blue for outpu
    view full answer...

  • Parts Needed to Convert a Factory 4-Way from a 2006 Nissan Pathfinder to a 7-Way
  • I believe I have a solution that will allow you to install a brake controller on your 2006 Nissan Pathfinder. But you will not be able to use the plug underneath the dash of your vehicle. You will need a 4 and 7 Way Installation Kit, # ETBC7. Your existing 4-Way will plug into the back of the ETBC7. There will then be 4 wires left to hardwire. Check out the installation instructions I attached for the # ETBC7 as well the installation video. The brake controller connector under the dash wil
    view full answer...

  • Bypassing Factory Transmission Cooler on a 2006 Nissan Pathfinder
  • It is possible to install a transmission cooler and bypass the factory transmission cooler on your 2006 Nissan Pathfinder. This is not recommended by manufacturers, but it is possible. You will want to get the largest transmission cooler that will fit your vehicle. I do not know the area that you have available to install a transmission cooler, but if it will fit, I would recommend the Derale Series 8000 Plate-Fin Transmission Cooler Kit, part # D13504. The overall dimensions for this cooler are
    view full answer...

  • Electric Fan for Transmission Cooler Recommendation for a 2006 Nissan Pathfinder
  • This Derale 10 inch Dyno-Cool Straight-Blade Electric Fan # D16310 that you referenced would be a good choice for additional cooling of the transmission cooler on your 2006 Nissan Pathfinder as long as there is room for this unit behind the cooler. This unit measures 11 inches wide by 11-1/4 inches tall and 2-3/8 inches deep, you will want to measure the area behind your cooler to make sure there is enough room. I have attached an FAQ article on electric fans for you to check out also.
    view full answer...

  • Installation of Brake Controller to Activate Trailer Brakes on a 2006 Nissan Pathfinder
  • To activate the electric brakes on your trailer you will need to install a brake controller in your 2006 Nissan Pathfinder. I would recommend the Tekonsha Prodigy P2 Brake Controller, part # 90885 which is our best selling brake controller. This is a proportional brake controller which means it applies power to the trailers brakes in proportion to vehicles braking action. To install the Prodigy P2 brake controller to your vehicle you will need to check if you have a factory brake controller p
    view full answer...

  • Installing a 7-Way Trailer Connector and Brake Controller on a 2006 Nissan Pathfinder
  • We do have a wiring harness that would be a great fit for your 2006 Nissan Pathfinder. You will need a 4 and 7 Way Installation Kit, # ETBC7. Your existing 4-Way will plug into the back of the ETBC7. There will then be 4 wires left to hardwire. The white wire gets connected to the vehicle frame. The black and blue wires get connected to the duplex cable and routed under the vehicle, avoiding areas that may pinch or burn the wires, into the engine compartment. The last wire is for reverse lig
    view full answer...

  • What is Needed to Set Up a 2006 Nissan Pathfinder to Tow a Trailer with Electric Brakes
  • The ETBC7 kit you were looking at coupled with a good brake controller like the Tekonsha Prodigy P2, part # 90885, would be all that is needed to set up your Pathfinder. Any trailer with electric brakes that uses a standard 7-way will plug in. I have added a light walk-through of how the ETBC7 is wired and have included links to a couple videos that may be helpful. Sine you have a 4-Way installed and working properly, you can start wiring your 7-Way. You will plug the 4-Way on the Nissan i
    view full answer...

  • Brake Controller Installation on a 2006 Nissan Pathfinder LE
  • If your Nissan Pathfinder LE does not have a factory 7-Way connector on at the rear of the vehicle then your vehicle was not equipped with the factory tow package. I do not have a picture of the Pathfinder with a factory connector available to send you. To install a brake controller and 7-Way RV plug on your Pathfinder you will need a brake controller like the Prodigy, item # 90185, that your referred to, a 4-Way connector item # 118263, and a Brake Controller 7 & 4 Way Installation Kit, item
    view full answer...

  • Tire And Wheel Recommendation For Trailer With 4.80x12 Tires On 4 on 4 Wheels
  • The 4.80 X 12 is the size of the tire and the 4 on 4 is the bolt pattern of the wheel. The bolt pattern means it is a 4 hole wheel and the distance from the center of one hole to the center of the hole directly across from it is 4 inches. Any wheel with a 4 on 4 inch bolt pattern and a large enough pilot hole diameter will fit your trailer. You will need to check the weight capacity of your axle and get the correct tire size that will be rated above the weight capacity of your axle. The 4
    view full answer...

  • How to Find the Brake Switch Stop Light Wire on a 2006 Nissan Pathfinder
  • I can tell you how to find the brake switch stop light wire on your 2006 Nissan Pathfinder. The brake switch is located above the brake pedal, under the dash. It will have numerous wires running into it. There will be any number of colors. There is a chance that the wire is red with a green stripe but wire color is not an exact science, and manufacturers might up and change the color in the middle of a model year. Since I cannot say what color the wire you need will for sure, you can find it usi
    view full answer...

  • Brake Controller Wiring on a 2006 Nissan Pathfinder
  • The blue wire coming from the 7 way at the rear would connect to the blue output wire coming from the brake controller. Typically this wire would run from the port under the dash to a location somewhere near the rear of the vehicle. Check the driver's side frame rail or behind the bumper for a blue wire that is not connected to anything. The black wire is for your 12V lead, and would run to a 12V power source via a 40 amp inline circuit breaker like part # 9510. The orange lead is either used fo
    view full answer...





Subscribe to email newsletter

Email  

privacy - we don't send unsolicited email




etrailer.com reviews etrailer.com reviews

All images, layout and content copyright etrailer.com