Trailer Hitch Installation - 2002 Ford Van - Draw-Tite
Today on our 2012 Ford E350, well be installing the Draw-Tite Ultra Frame Hitch, part number 41945. Next well go ahead and give you a couple of measurements to assist you in selecting accessories for your new hitch. From the center of the hitch pinhole to the outermost edge of the bumper is 3 inches. From the top of the receiver tube to the ground is 17 inches. This will assist you in selecting accessories such as bike rack or cargo carrier. As per the instructions, well go ahead and remove the rear vapor canister on the drivers side frame rail.
Trailer Brake Controller Installation Kit Installation - 2002 Ford Van
Today on our 2002 Ford Van well be installing the ETBC7 brake controller seven and four way installation kit part #: #TBC7. First well start at the back of the vehicle. Well mount the bracket for our sever four way plug. To mount the bracket well go ahead and set the bracket up where wed like to mount it and then using a paint marker well mark the holes thatll need to be drilled out. Because of the thickness of the bumper well use a small drill bit as a pilot hole and then step up to our larger size. Now with our holes drilled out well go ahead and take a couple of self-tapping screws and secure the bracket to the bumper.
Trailer Hitch Installation - 2002 Ford E-350 Van
Today on this 2002 Ford E-350 van, we are going to be installing Curt hitch part number 14055. Before we get started with our hitch installation, we are going to go ahead and show you a couple of final install dimensions which will help make choosing your hitch accessories a little bit easier. From the top of the receiver tube opening to the ground is going to measure 19-1/2 inches. And from the center of the pin hole to clear the rear edge of the bumper is going to be approximately 5-1/2 inches. And now we will go ahead and move on to our installation. 0:28
Trailer Hitch Installation - 2002 Ford E-350 Super Duty Van
Today on this 2002 Ford E-350 Super Duty Van, we are going to install part number 41926 from Draw-Tite. Now we are looking at the driver side of the vehicle frame rail and the hitch is going to mount up using this hole here, this one, and this one right here. It is going to be identical on both sides. This is going to be a really straight forward install. At this point we can already start installing our hardware. We are simply just installing blocks over the holes that we are going to use. Install another block here. And we repeat the same process back on the driver side. Now we can go ahead and put our hitch up, we just have to make sure that we have got a space there between the hitch and the frame at this spot here. If you notice, the frame overlaps here so we have got to take into account that, so it is a nice, straight, even plane. We will go ahead and start hanging the hitch.
