1998 Toyota 4Runner Accessories

1998 Toyota 4Runner Questions and Answers

What is the Correct Mounting Hardware for a Thule Weekender Cargo Box for a 1998 Toyota 4Runner
According to Thule you can use the QM3 mounting hardware, # TH04997, for the Weekender cargo box. The crossbars on your 1998 Toyota 4Runner will need to be up to 3-5/8 inches wide. I have included a picture that shows how this hardware will install.
view full answer...

Will the Thule Vertex Swinging Trailer Hitch Mount Bike Rack Fit a 1998 Toyota 4Runner
You will need to measure the distance from the center of the hitch pin hole out to the distance required to clear the rear of the vehicle. If that distance is less than 8-1/2 inches then the Vertex swinging rack # TH9031 will fit. The spare tire under the vehicle should not be a problem provided it is a factory sized spare mounted in the factory location. I have included instructions and video links on the bike rack for you. If you will be carrying womens, childrens, or alternative frame bik
view full answer...

Install Instructions for Curt Class III Receiver # 13157 on 1998 Toyota 4Runner
I have confirmed that the Curt # 13157 is indeed a fit for your 1998 4Runner. To view or print the installation instructions, click on the provided instruction link.
view full answer...

Roof Rack and Side Step Recommendations for a 1998 Toyota 4Runner
For side steps, we have several options for a 1998 Toyota 4Runner. I have included a link to the available options for you. For silver steps, we have # CARR103994 and # CARR124034 that you have referenced. I have included links to the installation instructions for each set for you. For a roof rack, there are 3 different roof options that were available on the1998 Toyota 4Runner. You could have factory tracks that run front to back, a plain roof with no rails, crossbars, or tracks, or a factor
view full answer...

Replacing a CURT Trailer Brake Controller with a Tekonsha P3 on a 1998 Toyota 4Runner
I believe that you have an older version of the CURT Discovery brake controller. The CURT controller and the Tekonsha P3, # 90195, use different connecting plugs. However, you could hardwire the P3 to the CURT wiring harness by cutting off the plug on the CURT harness. It looks like the CURT harness uses the same color/functions configuration as the P3. White is ground, black is 12 volt power, blue is output to the trailer, and red is input from the brake light circuit. Use a circuit tester
view full answer...

Wiring The Hayes Energize III Brake Controller # 81741B To A 1998 Toyota 4Runner
You will want to make sure the four remaining wires from your 4-flat to 7-blade adapter are connected as follows on your 1998 Toyota 4Runner: White: Ground wire, connected to a suitable grounding point on the vehicle frame. Blue: Electric brake wire, connected to the electric brake wire coming from the back side of your Hayes brake controller. Black: 12v power wire, connected to the vehicle positive battery terminal with a 40amp circuit breaker. Purple or Yellow: Used to power reverse l
view full answer...