Thule Traverse Roof Rack Installation - 2008 Acura RDX - Video
Alright, today on this 2008 Acura RDX we are going to install roof rack. We will be using parts from Thule and we will be using the following part numbers. First off, we are going to use the Traverse foot pack, this will be part number TH480. And then we are going to be using roof rack bars, THLB58. And then we are going to use a fit kit. And these are actually the parts that actually adapt the roof rack to the roof line of the vehicle itself. That is going to be part number THKIT1550. Alright, we will go ahead and assemble one side. It looks like there is a lot of parts but it is really easy to put together. So let us go ahead and remove the excess parts we need and go ahead and do one side. 0:37 more
Watch Video
Posted: 2/18/2010 7:49:19 AM
Yakima Q Tower Roof Rack Installation - 2007 Acura MDX - Video
Watch Video
Posted: 1/23/2012 2:25:41 AM
Thule Traverse Roof Rack Installation - 2009 Acura MDX - Video
Today on this 2009 Acura MDX we will be test fitting a Thule Traverse Roof Rack. We already have the load bars and foot pack assembled per the instructions, so we will go ahead and show you how it looks on the vehicle. First well open the car doors and place the first load bar onto the vehicle facing the front, positioning them close to the windshield. Next we measure from the end of the windshield to the edge of the foot pack, that should be 10 for this particular install. Once thats measured out on both sides you want to check and make sure the load bar is centered on the vehicle. Now we will snug them down and lock them into place using the provided Accue Tight measuring tool. more
Watch Video
Posted: 11/28/2011 4:10:30 PM
Thule Traverse Roof Rack Installation - 2007 Acura MDX - Video
Today we are going to show you how the Thule Traverse roof rack system looks and fits on a 2007 Acura MDX. First thing we are going to want to do is go ahead and open up the doors on our MDX and then we will take the pre-assembled crossbars and go ahead and set them into position. Now we have the front crossbar set in place we want to just make sure that it is in its proper position and to do that we are actually going to take a tape measure and we want to measure out from the top edge of the windshield to the front end of the foot pack and on this particular vehicle that measurement is going to be 10 inches. Once we have ensured that dimension is set we can go ahead and tighten our foot pack down using the provided one torque tool which helps take the guesswork out of how tight you need to get the foot pack. Okay just go ahead and close the lid on our foot packs and we will go ahead and move on to the rear crossbar and we are going to repeat the same setup for the rear crossbar. :50 more
Watch Video
Posted: 9/14/2011 1:15:00 PM
