Trailer Wiring Harness Installation - 2004 Saturn Vue - Video
Today on this 2004 Saturn Vue we are going to install part number 18002 from Tow Ready. On this vehicle we are going to attach it to the factory tow package. We will get in the back of the vehicle. The tow package is located inside the vehicle on the driver side behind and below the jack storage compartment. Then we will remove the jack itself. Follow this wiring harness down a little ways. You can see the tow package wires themselves. There will just be bare ends of wires right here. 00:33 more
Watch Video
Posted: 7/2/2010 3:45:16 PM
Trailer Wiring Harness Installation - 2006 Saturn Vue - Video
Today we are going to install part number 118418 from Tow Ready on our 2006 Saturn Vue. The general layout of this wire harness is that the connections are behind the tail lights, route the wires underneath the vehicle, and the wires will be stored outside the vehicle when we are done. To start off, we will take off the tail lights we will lift the hatch to get to those. All right, and here is our connection point right here. So let us pull this latch out and pull it apart. And repeat for the passengers side. All right, next we need to loosen this section of quarter-panel here to give us some room to run our connectors and put our black box for the T-harness hidden back up inside of here. What we are going to do is take out this nut here and this nut here, and that will give us enough wiggle room to pull the panel off just a little bit. more
Watch Video
Posted: 3/31/2009 9:15:08 AM
Trailer Wiring Harness Installation - 2003 Saturn Vue - Video
Today on this 2003 Saturn Vue we will be installing the converter part number 119130. The harness we are going to be installing is a hard wire harness. We are going to need to access the wires behind the tail light assembly in order to hard wire it in. To gain access to those we actually need to take the tail lights themselves off. To do that we have two screws here on the inboard side that we need to remove. That should allow us to get our tail light off. :24 more
Watch Video
Posted: 8/30/2009 7:50:19 PM
Trailer Wiring Harness Installation - 2007 Saturn Outlook - Video
Today on this 2007 Saturn Outlook we are going to install part number 118434 from Tow Ready. The first thing we need to do is open up the back hatch of the vehicle, that is where our wiring connections will be at. There are two attachment points behind these two little plastic covers so we just need to pop those off and get behind the screws behind them. Pull the light gently at an angle away from the vehicle and this is our connection point. This is going to plug in between these two halves of the connection point. We are going to push down this little lever right here and it pops right apart. 00:35 more
Watch Video
Posted: 10/11/2010 10:19:45 AM
Trailer Wiring Harness Installation- 2009 Saturn Outlook - Video
Today on this 2009 Saturn Outlook we are going to install 118434 from Tow Ready. The first thing we need to do is open up the rear hatch and get access to the tail lights. Now we need to remove the tail light itself, so we are going to remove these two covers, and the screws are behind the covers. Then we can pop off the light. Then we can disconnect the light from the vehicle. This latch right here will pull down. We have the driver side tail light removed, lets go to the passenger side and repeat the same process. :36 more
Watch Video
Posted: 7/27/2010 8:10:49 AM
Trailer Wiring Harness Installation - 2007 Saturn Ion - Video
Today on this 2007 Saturn Ion we are going to be installing wiring harness part number 119175KIT. We are in the trunk area of the Ion and we want to locate the wires that we are going to be tapping into. Starting over on the driver side we have got the wires going into the tail light assembly from the inside and these are going to be the wires we are going to tap into. We can count for four of the wires for the harness over on the driver side. We are going to have to route one wire over to the passenger side to activate the right turn signal. I am going to pull back the carpeting a little bit so that when I tap into the wires they are somewhat hidden. I am going to cut back some of the tape here that is covering the wires. Be careful not to slice any of the wires inside when doing this. 00:38 more
Watch Video
Posted: 5/26/2010 12:07:43 PM
