Trailer Hitch Installation - 2004 Volvo XC90 - Video
Today we will be working on a 2004 Volvo XC90. We will be installing Hidden Hitch part number 87810. This is also comparable to Draw-Tite hitch part number 75152. Here are a couple measurements that will help you in ing accessories for your new hitch. From the center of the hitch pin hole, to the outer edge of the bumper is 5 inches. From the top of the receiver tube to the ground is 15 inches. :24 more
Watch Video
Posted: 7/8/2011 1:06:51 PM
Trailer Hitch Installation - 2006 Volvo S60 Sedan - Video
Today on this 2006 Volvo S60 Sedan we are going to be installing part number 36297 from Draw-Tite. The first thing we need to do is remove the tow bracket on the passenger side of the vehicle. Keep a hold of the bolts, but put the tow bracket off to the side because we are going to be using the bolts for the installation. Now we are going to go to the driver side of the vehicle and lower down the exhaust bracket. We are also going to be putting our hitch in that position using the exhaust bracket bolts. :32 more
Watch Video
Posted: 6/22/2010 2:29:52 PM
Trailer Hitch Installation - 2010 Volvo XC90 - Video
Today on this 2010 Volvo XC90 we are going to be installing part number 87810 from Hidden Hitch. This also applies to part number 75152 from Draw-Tite. The first thing we are going to do is lower the tow hooks on the passenger side frame rail. We will no longer be using this on the vehicle. The mounting locations for the passenger side are going to be these three existing weld nuts. It is going to be the exact same on the driver side but we are going to have to lower the exhaust bracket to gain access to those holes where we are mounting. 00:30 more
Watch Video
Posted: 6/3/2010 12:52:53 PM
Trailer Hitch Installation - 2003 Volvo S40 - Video
Once were inside the trunk area, we need to get to the spare tire which has to come out so we dont poke a hole through it when we drill. What well do next is hang the hitch from the tow loop right here, then well put the hitch in position and that will mark our holes to drill out. What we do next is tighten this bolt down so when we push it up it will stay in position to mark our holes out. With our hitch in position well drill out our holes, its really thin metal and it wont be any trouble at all. As you can see we have our holes drilled out, what were going to next is put a little ring of silicone around them, to seal the holes so no exhaust fumes get up inside the cabin. The next step is to the bolts into place. Now well go back underneath the vehicle to make sure they fed through and well start tightening them down. What well do now since one of our bolts has come through the hitch already, well put our nut and washer on loosely. Then well go back here and loosen this up so we have room to work with this. Now that we have them started, well tighten these down, snug them up and then do our final torquing. Now that we have everything snugged up and looking good, well torque everything down. The hitch is installed, the last thing to do is put the spare tire back in and reassemble the trunk and were good to go. Thats all it takes that was part # 24688 for an 2003 Volvo S40 Sedan. more
Watch Video
Posted: 7/23/2008 6:35:17 AM
