The port is tucked up right here, but we popped it out so you can see it better. This is a pretty simple process, just go ahead and push this down, pull it out, get your T connector, line up the slots and pop it back in there. The hard part is finding a place where you want to mount it to get it out of the way. What well do is use this screw that goes through this hole here. Hold it to where you want it, make a few marks with it and then draw the marks. We then drill a hole and re-attach the screw.
After attaching this here we ran our wires across behind the hitch and there is a wire harness back up in here. We had to zip tie the excess to take up the slack. We did that here and way up here you can feel the harness next to the hose and you can zip tie all of them, probably all three would be fine right there. That will conclude the install.
Today on our 2001 Isuzu Rodeo well be installing Tow-Ready T1 Connector part number 118360. To begin our installation, well need to remove the taillights from the vehicle. Well remove the Phillips head screw directly underneath the taillight between the taillight and the bumper fascia. We can then remove the two Phillips head screws here on the side of the taillight. And with those three Phillips head removed, the taillight simply come right off. We can then go ahead and unplug the taillight assembly from the vehicle.