
customer service | view cart

Custom Fit Vehicle Wiring
This Product Fits The Following Vehicles
1996 - 2009 Chevrolet Express Van with 7-wire Tow Package
1996 - 2009 GMC Savana Van with 7-Wire Tow Package
2000 - 2005 Ford Excursion with factory 4-Flat
1997 - 2008 Ford Expedition with factory 4-Flat
1994 - 2009 Ford F-150 with factory 4-Flat
1994 - 1996 Ford F-250 and F-350 with factory 4-Flat
1997 - 1998 Ford F-250 and F-350 Heavy Duty with factory 4-Flat
2002 - 2009 Ford F-250 and F-350 Super Duty with factory 4-Flat
2005 - 2009 Ford F-350, 450, and 550 Cab and Chassis with factory 4-Flat
2006 - 2008 Lincoln Mark LT with factory 4-Flat
1998 - 2008 Lincoln Navigator with factory 4-Flat
1995 - 2009 Dodge Ram Pickup with factory 4-Flat
1992 - 2009 Ford Van with factory 4-Flat
1994 - 1996 Ford F-150 without factory trailer connector
1997 - 2003 Ford F-150 and F-250 Light Duty without factory trailer connector
2004 - 2004 Ford F-150 Heritage Series without factory trailer connector
Today we are going to install part number 37185 on our 2006 Dodge full size pickup 1500 with the 4 pole wiring flat installed from the factory. To begin our install the bumper already has a knockout ready for a 7 pole trailer connector. All I have to do is pop off this cover and it is ready to go. Next we can go ahead and install our 7 pole. Basically you just plug it right in and then give it a little push so it snaps into place. Now we can go ahead and install our hardware. We can now move under the vehicle to make some of our final connections here. In this application we are just going to install the 4 pole. There is not a brake controller or hot lead being used so we will bind this all back up and tuck it out of the way. We will go ahead and install some dielectric grease in here then install them together.
Then we want to run a zip tie all the way around them to keep them together. If this was going to be a permanent installation than you can go ahead and wrap it in electrical tape for extra security. Next we will take our white wire for grounding and lets go run it over the hitch and the frame. Then back down to the frame and this is where we will install a ground screw. Then we will take our left over wires and leave the ends out available for expansion later if needed. We will go ahead and zip tie it back up behind the bumper. That concludes our install of part number 37185 from Hoppy on a Dodge 1500 full size pickup.
Questions About Part 37185
Installation Instructions for 4 Pole to 7 and 4 Pole Adapter part # 37185
Installation of 7-Way and 4-way Connector on 2008 Dodge Ram Pickup with factory 4-way Connector
Instructions Needed for Wiring a 4-Way to 7-Way Trailer Connector on a 2008 Dodge Durango
Charging a Trailer Battery While Towing
Brake Controller Wiring on a 2005 Ford F-150 without a Tow Package
4 Pole to 7 Pole & 4 Pole Wiring Adapter
Brake Controller Wiring on a 2000 Chevy Silverado