
customer service | view cart

Custom Fit Vehicle Wiring
This Product Fits The Following Vehicles
1997 - 1997 Jeep TJ
1991 - 1997 Jeep Wrangler
1991 - 1996 Jeep YJ
Today we are going to install part number 118356 from Tow Ready, and we are going to install this on a 1996 Jeep Wrangler. OK, we will start off by positioning our 4-pole flat behind the hitch, and we are just going to leave it loose like that for now. And we will run our wires to the drivers side and the passengers side. Starting with the passengers side, which will be the green and white wires, we are going to run it behind the hitch itself, because there really is not anywhere else where you can hide the wiring on this particular vehicle. So, it is going to take quite a few zip-ties to hold everything in place. And our junction point will be up here, behind this plastic here, approximately in this area here. All right, we will just take down this plastic right here.
The connection is underneath all this tape right here, so we have got to take this tape off and disconnect the two halves. And it is kind of difficult to see, but once you get the two halves disconnected, the T-1, and it snaps into place. And the other half will go back inside of here. Next what we will do is we will take our ground wire and run it right to the side of the frame and attach it right there. OK, we want to put our plastic cover back together in the vehicle. All right, and we will repeat the same process on the other side of the vehicle, on the drivers side. And put our plastic cover back into place. With the wires properly zip-tied, that will finish your install of part number 118356 from Tow Ready on our 1996 Jeep Wrangler.
Questions About Wiring Harness Installation - 1996 Jeep Wrangler