Today on this 2012 Honda Accord Cross Tour we're going to install part number 118500 from Tow-Ready. Our first step is to go ahead and remove all floor coverings and the center storage bin. Now to remove the drivers side cargo tray there's a small cover we have to lift up and the bolts underneath it. We'll go ahead and remove the bolt and then remove the cargo tray. After we remove the tray if you look towards the bumper underneath the carpet you should see a connector wrapped up in blue tape. We'll go ahead and release the blue tape and then pull the connector out.
Today we are going to be installing wiring harness part number 118302 on a 2006 Honda Accord. We are inside the trunk area here. The connection points are actually located behind the tail light assembly, so we are going to need to remove this rear threshold piece. There are push rivets located here that are holding the threshold piece on. I am going to take a flat-bladed screwdriver and just gently pull up. OK, next I am going to go ahead and remove the carpeting. To do so, there are two Phillips-head screws that we are going to take out. We are going to remove the plastic plugs that are in here as well, and that will allow us to pull the carpeting back here. So here on the drivers side we are going to go ahead and make all three of our connections.