Today on 2008 Saturn Outlook we're going to install of part number 75528 from Draw-Tite. We'll also apply to part number 87435 for Hidden Hitch. This is what the hitch looks like once install on the vehicle. Next, well give some measurements that help you out in selecting the some accessories such as a bum out, a bicycle rack or a cargo carrier. From the center of the hitch pin to the edge of the bumper were looking at 3- and from the top of the receiver opening down to ground were looking at 18-1/4 .Now, were going to show you how the hitches install. All right, well go ahead and show you hitch mount stop unto the frame.
Come out here and here is your threaded holes it's going to be the same on both sides and then at the center of the bumper behind the station that will be removed there are two more threaded holes.Before installing our hitch, they get it to clean up the threads. In this case well be using some spray lubricant and two brush part number 814092. This point well go ahead and lower the exhaust down the global room for installation. What were going to have to do is spray down the rubber hanger some lubricant and make it easy to remove. At this point well go ahead and start installing the hitch.
Now, how are were going to the bumper structure is going to require a next space of block. For how we start it we go ahead and snug down the bolt then took them down as specified of the instructions. With the hitch install well go ahead and re-install the exhaust. And with that, that will finish it for install part number 75528 from Draw-Tite.Filename: Page 1 of 1Order #: 144539532 .
Trailer Hitch Installation - 2007 Saturn Outlook
Today on this 2007 Saturn Outlook we are going to install part number 75528 from Draw-Tite. This will also apply to part number 87435 from Hidden Hitch. As showing here the hitch is already installed on the vehicle. From the top of the receiver tube down to the ground is going to be 18-3/ 4 inches. From the center of the hitch pin out to the outside edge of the bumper is going to be about 4-1/ 2 inches. Next we are going to show you how it got there. The first thing we need to do is remove the rear fascia door that is basically at the bottom of the vehicle bumper cover. The next thing after that we will lower the exhaust. There are two rubber hangers on each side of the exhaust pipes. 00:38
Trailer Hitch Installation - 2009 Saturn Outlook
Today on this 2009 Saturn Outlook we are going to install part number 75528 from Draw-Tite. This also applies to part number 87435 from Hidden Hitch. The first thing we need to do is remove this small panel at the bottom of the bumper here. There are two little tabs that you just twist, it removes, that is it. The actual panel itself will stay off because the hitch will be in the way from here on out. :26
