Today, on this 2010 Toyota Camry, well be doing a test fit of a Thule Aeroblade roof rack with the diverse foot packs. Well start off with the bars already assembled and well place them on top of the vehicle. To position the bars properly well measure from the edge of the wind shield to the leading edge of the foot pack. Always go by the instructions, however this measurement will be 9 inches. To position our rear bar, we are going to measure from the center of the front bar to the center of our rear bar. This measurement will be 26 and inches.
With both bars in place, well begin tightening them down. Well begin by tightening the slack on both sides by using the included torque tool, well tighten them down for good. Well repeat the same process with the rear bar and when were finished the tools well store inside the foot pack. Now that we have both bars in place, well give you some measurements of how much height was added to the vehicle. Measuring from the top part of the vehicle to the bottom of the foot pack will add about 5 and inches.
And with that were finished with the test fit of our Thule Aeroblade roof rack on our 2010 Toyota Camry.
