Today on our 2008 Subaru Legacy GT with 215 / 45 R17 tires, well be test fitting the Thule Self-Tensioning Low Profile snow tire chains part number TH00023090. First well lay out the chains and make sure everythings in order. Then well take the blue plastic coated cable side and feed it around the inboard of our tire. Well lift it up to the top of the tire and hook the cable stop back into the keyhole. Well connect these two pieces of chain together here. We can move out a couple lengths to take out some extra slack in the chain and well use this plastic clip to secure the excess then we can center the chains on our tire.
Next well take the ratcheting cable and feed it through the ratchet pulley system. Well connect it through our tensioner and the chain will start to tension itself. Next, well drive a little bit to let the chain self-center and self-tension properly against the tire. With that done, our chains installed and were ready to hit the roads. And thats it for our test fit of the Thule Self-Tensioning Low Profile tire chains part number TH00023090 on our 2008 Subaru Legacy GT with 215 / 45 R17 tires..
Speaker: Today were working with a 2008 Subaru Legacy GT with 215-45-17 tires. Were going to be test fitting the Thule Self-Tensioning snow tire chains, part number th00204090. Before mounting the chains make sure to check the owners manual of your vehicle for further information about using tire chains. Well take our tire chain and lay it flat. We need to feed the blue cable around the backside of our tire. We want to make sure that the yellow end is on the right hand side of the tire as we face it.
Speaker: Today were working with a 2008 Subaru Legacy GT. It has 215 by 45 by 17 tires and were going to be test fitting the Pewag Sportmatik Self-Tensioning snow tire chains, part number pwsmx69. Once weve taken the chain out of the box we need to prep it for fitting onto our tire. Be sure to check the owners manual of your vehicle for further instructions about tire chains. We need to take the socket and separate it according to the direction of the arrow stickers. Next we need to take the two tensioners on the chain, toggle them into the open position and pull the slack all the way out of the tensioner.