Today on our 2010 Hyundai Santa Fe we're going to be test fitting the Thule Hitching Post Pro Folding and Tilting 4 Bike Carrier, part number TH934XTR. With our vehicle equipped with the 2-inch hitch and our bike rack already preassembled we'll go ahead and slide the bike rack shank directly into the receiver tube of the hitch lining up the hitch pin holes. Then we'll install and tighten down my anti-rattle bolt. This is what our bike rack will look like in its stored position. Next, we'll go ahead and give you a few measurements. From the nearest point of our bike rack upright to the nearest point of the bumper is 6 inches.
From the lowest point of the rear of the bike rack we have 11-3/4 inches of ground clearance. With our bike rack installed and in the stored position we add an additional 17 inches of overall length to the vehicle. Now we'll go ahead and pull the pin tilting the bike rack away from the vehicle so we can gain rear cargo access. As you can see with the bike rack tilted away from the vehicle we still can gain full rear cargo access. Now let's go ahead and put the bike rack back into the upright position.
Next, we'll go ahead and pull the pin on top of the mast so that we can extend the carrying arms and lock them in the upright position. With the arms up and locked in position we'll go ahead and remove the hold down straps so we can set our bike directly into position. Now with our bike in place we'll go ahead and use the hold down straps to secure it. And just like that in a few simple steps we've gone ahead and secured the bike to the bike rack and the bike rack to the vehicle. Now we're ready to hit the road.
And that does it for our test fit of the Hitching Post Pro Folding and Tilting 4 Bike Carrier, part number TH934XTR on our 2010 Hyundai Santa Fe.
Yakima HighLite 2 Hitch Bike Rack Review - 2012 Hyundai Santa Fe
Today on our 2012 Hyundai Santa Fe we'll be test fitting the Yakima Highlite aluminum two bike carrier, part number Y02438. Now to begin our test fit we'll slide the shank of the carrier into the opening of the hitch, line up our pin holes, insert the attached pin into the pin hole and turn the black knob to engage our anti-rattle bolt. Now we'll go over some clearance measurements to see how the bike carrier and this vehicle will fit together. There is about 11 1/2 inches of ground clearance. Closest part of the vehicle to the closest part of the carrier at the bottom of the bumper is about 4 inches. With the cradle arms folded down we've added about 10 inches to the overall length of the vehicle measured at the bumper.
Yakima DoubleDown Ace Hitch Bike Rack Review - 2012 Hyundai Santa Fe
Today on our 2012 Hyundai Santa Fe we'll be test fitting the Yakima Doubledown Ace four bike carrier, part number Y02451. Now to begin our test fit we'll slide the shank of the carrier into the opening of the hitch, line up our pin holes, insert the attached pin into the pin hole and turn the black knob to engage our anti-rattle bolt. Now we'll go over some clearance measurements to see how the bike carrier and this vehicle will fit together. There is about 11 inches of ground clearance. Closest part of the vehicle to the closest part of the carrier at the bottom of the bumper is about 5 inches. With the cradle arms folded down we've added about 12 inches to the overall length of the vehicle measured at the bumper.
Thule Vertex 4 Hitch Bike Rack Review - 2012 Hyundai Santa Fe
Today on our 2012 Hyundai Santa Fe we'll be test fitting the Thule Vertex four bike carrier, part number TH9029. Now to begin our test fit we'll slide the shank of the carrier into the opening of the hitch, line up the pin holes, thread our anti-rattle bolt through the pin holes and tighten with a wrench. Now we'll go over some clearance measurements to see how the bike carrier and this vehicle will fit together. There is about 12 inches of ground clearance. Closest part of the vehicle to the closest part of the carrier is about 3 inch at the bottom of the bumper. With the cradle arms folded down we've added about 12 inches to the overall length of the vehicle measured at the bumper.
Thule Apex 4 Swing Hitch Bike Rack Review - 2012 Hyundai Santa Fe
Today on our 2012 Hyundai Santa Fe we'll be test fitting the Thule Apex swing, four bike carrier, part number TH9027. Now to begin our test fit we'll slide the shank of the carrier into the opening of the hitch, line up our pin holes, insert the spring loaded pin through the pin hole and tighten down the knob to engage our anti-rattle device. Now we'll go over some clearance measurements to see how the bike carrier and this vehicle will fit together. There is about 12 inches of ground clearance. Closest part of the vehicle to the closest part of the carrier at the anti-rattle knob is about 1 inch. With the cradle arms folded down we've added about 10 inches to the overall length of the vehicle measured at the bumper.
Thule Apex 4 Hitch Bike Rack Review - 2012 Hyundai Santa Fe
Today on our 2012 Hyundai Santa Fe we'll be test fitting the Thule Apex four bike carrier, part number TH9025. Now to begin our test fit we'll slide the shank of the carrier into the opening of the hitch, line up the pin holes, insert the spring loaded pin into the pin hole and turn the black knob to engage our anti-rattle device. Now we'll go over some clearance measurements to see how the bike carrier and this vehicle will fit together. There is about 12 inches of ground clearance. Closest part of the vehicle to the closest part of the carrier at the anti-rattle knob is about 1 inch. With the cradle arms folded down we've added about 13 inches to the overall length of the vehicle measured at the bumper.
Swagman XTC2 Wheel Mount Hitch Bike Rack Review - 2012 Hyundai Santa Fe
Today on our 2012 Hyundai Santa Fe we'll be test fitting the Swagman XTC 2 two bike carrier, part number S64670. Now to begin our test fit we'll slide the shank of the carrier into the opening of the hitch, line up the pin holes, thread our anti-rattle bolt through the pin holes and tighten with a wrench. Now we'll go over some clearance measurements to see how the bike carrier and this vehicle will fit together. There is about 12 inches of ground clearance. Closest part of the carrier to the closest part of the vehicle here at the rear bumper is about 8 inches. We've added about 24 inches to the overall length of the vehicle measured from the rear bumper.
