Today on our 2007 Honda Odyssey, well be test fitting the Swagman XTC 2, part number S64670. To begin our test fit, well simply place the bike rack shank into the hitch, line up the hitch pinhole, and install our anti-rattle bolt. With our bolt secure, this is what your bike rack would look like on your vehicle. Now, well give you a few measurements. At the bike rack, your ground clearance is 13-1/4 inches and from the closest point of the bike rack to the back of the vehicle is 3-1/2 inches. Now, well go ahead and fold the platform down and open our cargo door.
And as you can see, we can gain full access to the cargo area with this bike rack. Were now almost ready to load our bike. Well need only to open up the wheel loop straps and make sure theyre out of the way and well fully extend our vertical bar clamps. We can then place the bike into the wheel loops and bring our vertical bar up, remembering to reinstall the pin, holding the bar in place where we can then pull the top bar clamp down over our bike, securing it to the bike rack. Well then move back to the wheel loops, putting the straps through the wheels and securing them in on the other side.
And there you have it. Our bike is loaded and were ready to hit the road. And that completes our test fit of the Swagman XTC 2, part number S64670, on our 2007 Honda Odyssey.
Yakima HoldUp 2 Hitch Bike Rack Review - 2013 Honda Odyssey
Today on our 2013 Honda Odyssey well be test fitting the Yakima HoldUp 2 Bike Carrier part number Y02443. To begin our test fit well slide the shank of the carrier into the receiver tube of the hitch, line up the pin hole and thread in our anti-rattle bolt tightening it with a wrench. Now well go ahead and go over a few clearance measurements. We have about 15 inches of ground clearance. The closest point of the carrier to the rear of the vehicle is about 1 inch. With the bike carrier in the folded position weve added about 8 inches to the overall length of the Odyssey.
Yakima DoubleDown Ace Hitch Bike Rack Review - 2013 Honda Odyssey
Today on our 2013 Honda Odyssey, well be test fitting the Yakima DoubleDown Ace 4 Bike Carrier, part number Y02451. To begin our test fit, well slide the shank of the carrier into the receiver tube of our hitch, line up the pinhole and install the included pin. Then well move to the rear of the shank and use the hand knob to secure our bike rack to our vehicle and engage our anti-rattle device. Now well go ahead and go over a few clearance measurements. We have a ground clearance of 9 inches. The closest point of the carrier to the rear of the vehicle is about 2 inches.
Thule Helium Aero Hitch Bike Rack Review - 2013 Honda Odyssey
Today on our 2013 Honda Odyssey well be test fitting the Thule Helium Aero 2-Bike Carrier, part number th9042. To begin our test fit, well slide the shank of the carrier into the receiver tube of the hitch. Well allow our included pin to fall into place and then move to the rear of the shank and use the hand knob to secure our bike rack to the vehicle and engage our anti-rattle device. Now well go ahead and go over a few clearance measurements. We have about 14 inches of ground clearance. Weve added 15 inches to the overall length of our Odyssey.
SportRack Super EZ Hitch Bike Rack Review - 2013 Honda Odyssey
Today on our 2013 Honda Odyssey, we'll be test fitting the Sportrack Super EZ platform style 2-bike carrier, part number SR2901LR. To begin our test fit, we'll slide the shank of the carrier into the receiver tube of our hitch, line up the pin hole, and thread in our anti-rattle bolt, tightening it with a wrench, and then securing with a lock on the other side. Now we'll go ahead and go over a few clearance measurements. We have about 12-1/2" of ground clearance. The closest point of the carrier to the rear of the Odyssey is about 5". We've added 22" to the overall length of our Honda Odyssey.
Prorack 2 Hitch Bike Rack Review - 2013 Honda Odyssey
Today, on our 2013 Honda Odyssey, we will be testing the Pro Rack II Bike Carrier, part number PR-8062403. To begin our test fit, we will slide the shank of the carrier into the receiver tube of our hitch, line up the pinhole and thread in our anti-rattle bolt, tightening it with a wrench and installing the clip on the other side. Now, we will go ahead and go over a few clearance measurements. We have about 9.25 inches of ground clearance. The closest point of the carrier to the rear of the vehicle is about an inch. We have added 21 inches to the overall length of the Odyssey.
Prorack Platform Style Hitch Bike Rack Review - 2013 Honda Odyssey
Today on our 2013 Honda Odyssey well be test fitting the ProRack 2-Bike Carrier platform style, part number PR8062400. To begin our test fit, well slide the shank of the carrier into the receiver tube of the hitch, line up the pin hole, and thread in our anti-rattle bolt tightening it with a wrench and installing the clip on the other side. Now well go ahead and go over a few clearance measurements. We have about 14 inches of ground clearance. The closest point of the carrier to the rear of the Odyssey is about 2 inches. Weve added 19 inches to the overall length of our Honda Odyssey.
