Today we have with us a 2007 Hyundai Santa Fe and were going to be test fitting the Rockymounts Tierod Roof Mounted Bike carrier part number RKY1014. Our vehicle already has a full factory roof rack so were ready to go ahead and mount our bike rack to the bars. To fit our bike rack, well place it on top of our bars and put the head of the rack on our front bar making sure its wrapped the rubber-coated steel strap on the bar. Well fit them back into the head and tighten them down with the Allen key. Once weve done that, we can reinstall the cover of the head of the bike rack. At the back of the bike rack, well take our rear clamp, fit it around the bar and use the included wing nut to tighten it down.
Once weve done that, the bike racks attached and were ready to load up a bike. Well make sure that the front skewer is open and unlocked and well also make sure that the wheel strap is undone on the rear. Next, well place the bike into the carrier. Well pick it up, put the rear wheel into the tray and drop the front fork into our skewer. Well secure the bike first by the skewer then use the strap at the rear to secure the rear wheel.
With that, our bikes all loaded up and were ready to hit the road. That does it for our test fit of the Rockymounts Tierod Roof Mounted Bike carrier part number RKY1014 on our 2007 Hyundai Santa Fe.
Today on our 2007 Hyundai Santa Fe, we're going to be test fitting the Yakima ForkLift Roof Mounted Bike Carrier, part number Y02098. Our Santa Fe already has a factory roof rack system on it, so well be installing the forklift directly to the factory crossbars. Well take the bike rack and place it up on top of our crossbars. We'll fit the front clamp around the front crossbar and use the wing nut and T-bolt to tighten it down. Then we'll slide our cover back into place and we'll move to the rear. We'll fit the rear clamp around the rear bar and again we'll use the T-bolt and wing nut to tighten that down.
Today on our 2007 Hyundai Santa Fe, we're going to be test fitting the Yakima FrontLoader Roof Mounted Bike Rack, part number Y02103. Our Santa Fe is equipped with a factory roof rack so we're going to mount our FrontLoader directly to that. To mount the FrontLoader, we'll lift it up and place it on top of our crossbars. We'll take the head of the bike and fit the front clamp around our front bar and we'll use the hand nut to tighten it down. In the rear, we'll fit the rear clamp around the bar and use the T-bolt and wing nut to tighten it down. Once we've done that, our bike rack is secured and we're ready to load up a bike.
Today on our 2010 Hyundai Santa Fe, well be test fitting the RockyMounts Tie Rod roof-mounted bike carrier part number RKY1014. To begin our test fit, well place the bike rack on top of our factor cross bar, well move to the rear mounting point where well undo the wing nut and bring the clamp underneath the crossbar where well use the wing nut to secure the rear clamp. Well move up to the front crossbar where well use the rubber-coated steel straps to go underneath the crossbar and hook back to the head of the bike rack. We can then use the Allen wrench included with the bike rack to tighten down the Allen bolt securing our rubber-coated steel straps to the front crossbar. With that done, we can reinstall the head cover on our bike rack and now were ready to load up our bike. Well take the front wheel off of our bike and place the bike on top of the bike rack.