Today on this 2011 Chevrolet HHR, we're going to do a test fit product number RG8015220 from Rhode Gear. This is the Highway 2 Bike Carrier. One quick note about this bike carrier, this will work on an inch and a quarter receiver hitches class 1 and class 2 and also 2-inch by 2-inch trailer hitch receivers also with the included bushing. In this application, we'll be using the class 1 hitch. We'll start off by installing the bike rack into the hitch and then tighten down the anti-rattle bolt, and then put in the safety clip on the other side. We'll also be using a 3 and quarter-inch wrench to tighten it down.
Alright, next, we'll give you some measurements that will give you an idea of clearance between the bicycle rack and the car and the bicycle rack and the ground, ok The closest point from the post to the bumper is going to be 4 inches and ground clearance is going to be 8 inches, ok We'll go ahead and tilt back the bicycle rack and we'll check for access to the back of the vehicle. We'll pull out the safety pin clip and pull out the pin at the bottom. It looks like we have access to the back of the vehicle. Let's go ahead and tilt the bike rack back up and load up the bike. First, we'll go ahead and strap the cradles and we can load the bike.
And notice, the cradles can be rotated as well. In a few steps, our bike is already loaded up and we're ready to go. And that will finish it for our test fit of product number RG8015220 from Rhode Gear on our 2011 Chevrolet HHR.
Swagman XTC2 Wheel Mount Hitch Bike Rack Review - 2011 Chevrolet HHR
Alright today on this 2011 Chevrolet HHR we're going to do a test fit of part no. S64670 from Swagman. This is the XTC2 bike rack. Quick note about this bike rack, this will work with an inch and 1/4 receiver hitches both class 1 and class 2. This will also work with class 3 receiver hitch with the provided spacer. We'll start off our test fit by installing the bike rack into the hitch.
Thule Vertex 4 Hitch Bike Rack Review - 2011 Chevrolet HHR
Alright today on this 2011 Chevrolet HHR, were going to do a test fit for part number TH9029 from Thule, the Vertex 4 Bike Carrier. One quick note about the bicycle rack, this will work with 1-1/4-inch receiver hitches both class 1 and class 2. However, on a class 1 receiver hitch, youre only limited to carrying two bikes. This will also work with a 2-inch receiver hitch with the included spacer. Well go ahead and start off our test fit by installing the bike rack into the hitch and tightening down the anti-rattle bolt. Ok, with the hitch in place, well go ahead and give you some measurements that will give you an idea of clearance between the bike rack and the bumper and ground clearance as well.
Thule Apex 4 Hitch Bike Rack Review - 2011 Chevrolet HHR
All right, today on 2011 Chevrolet HHR we'll do a test fit of part number TH9025 from Thule, the Apex 4 hitch Bike Carrier. A quick note about this bicycle rack is that will work of 1-" receiver hitches both class I and class II have only limited two bikes from a class I hitch. This will also work of a 2" receiver hitch with the provided spacer.Well go ahead and slide the bike rack into the hitch and make sure the integrated locking pins snaps in the place where the hitch pin in place we go ahead tighten it down the knob for anti-rattle device. OkayNow we can go ahead and use measurements of giving an idea of clearance between the bike rack and the bumper. We also give you a measurement from ground clearance as well. As closest point to the bumper bike rack is 3" away and ground clearance will be 8-".
Thule Helium Hitch Bike Rack Review - 2011 Chevrolet HHR
Alright today on this 2011 Chevrolet HHR were going to do a test fit of part number th970xt from Thule. This is the Thule Helium Aluminum 2 Bike Carrier. One quick not about this bike carrier is that it will work with 1-1/4 receiver hitches class one and class two. We will be using a class one hitch today, and this will also work with 2 receiver hitches with the included bushing. Well start off by installing the hitch into the bicycle rack, putting the pin into the hitch hole. Its keyed so insert it and turn it 90 degrees, and then we will pull back a little bit and tighten down the anti-rattle lock.
Thule Doubletrack Hitch Bike Rack Review - 2011 Chevrolet HHR
Today on this 2011 Chevrolet HHR, were going to do a test fit of part number th990xt from Thule. This is a double track platform carrier. One quick note about this bicycle carrier, this will work with class one and class two receiver hitches. We will be using a class one 1-1/4 for this demonstration. This will also work with 2 receiver hitches with the included spacer. We will go ahead and start off by installing the bike rack into the hitch, well tighten down the anti rattle bolt and then go ahead and put our lock on the other side.
