Today on our 2012 Toyota 4 Runner, we're going to install the Husky Liners Custom Molded Mud Flaps part number HL56921. This set comes with two pieces one for the driver and one for the passenger side. Well go ahead and take the driver side and kind of fit it into place. This will allow me to take a measurement or a mark so I know I need to clean from this point to the bottom edge of the paint so that we can apply a clear plastic film. The clear plastic film will go in between the mud flap in the body this will help protect the paint. So, Ill go ahead and take a cleaner here, spray down the area, wipe it clean and make sure we have the entire area dry as we next going to go back with the soap and water mix and apply to the surface.
This will allow us to put our clear film in place and move it around as necessary to get in position. With our soap and water apply we can go ahead and take our clear film and this going to start it up the paper that comes from install kit. With some kind of comfort it for guys started for now we'll go and remove the rest of the paper and roll out the rest of the film.Next we can take a squeegee, a brush or soft household spatula, drag it along the clear film to push out any water or air bubble. Now, while we're letting our clear film dry and set up, we're going to address the mini mud flap. Some application will have will have this mini mud flap.
If you do it will be necessary to cut off the bottom edge of it so that we can install the new mud flap. So, next time well go ahead, remove it, take the utility knife, cut it off and then reinstall it.To remove it weve got two plastic push pins and a Phillip screw. Plastic push pins can be removed by prying the center cap out and then remove in this push pin fastener. We take a tape measure we're going to cut off about approximately the bottom 2. Now, what we're going to do is go ahead and re install it only will only be using the top few fasteners.
Now, we have the mini mud flap reinstalled. Were going to ahead and remove the two inner wall fasteners. Hang on these fasteners that we will reuse them when we install the mud flap. Now, this will give us three attachment points from the mud flap. The inner wall fastener at the top, it will fasten to the bottom and then a mud flap attachment point.Lets go ahead and put a new mud flap in position.
Well reinstall the inner fender well screws. For our bottom attachment point, well be using these screw and fastener supply with our install kit. The fastener will go behind the mud flap and inner fender well. To all three fasteners in position we'll go ahead and tight them down. Now, with all three fasteners tighten down we'll go ahead and reinstall our tire wheel and that complete the installation of our Husky Liner Custom Molded Mud Flap part number HL56921 on our 2012 Toyota 4 Runner. Filename: Page 1 of 1Order #: 144539532 .
