On this 2009 Chevrolet Silverado extended cab, we're going to install part number HL53101. This is the exact contour custom auto floor liners for the front row from Husky Liners. To start off, we need to go ahead and remove any existing liners that are on the floor. We want to get down to the bare carpet. Then we'll take our new liner and put it into place. We've adjusted the fit to match the contour of the floor, where the floor goes up and down.
It also has a raised edge along the threshold by the door. It covers up the gap between the threshold and the carpet. It goes up behind the pedals about half way, and covers up the foot rest. It has a reinforcement for your shoes. It has raised ribs in the middle to allow snow and water to drain from your shoes. Now we'll go ahead and take a look at the passenger's side.
It has the same ridge up by the threshold, which goes all the way around. Plus, it goes about halfway up the floorboard underneath the dash. Now when we lift up one corner, you can see the points on the bottom called nibs. This is what grips the carpet. It's easy to install; it will be as easy to remove and clean.
Simply just hose them off with soap and water, and allow to dry. That will finish it for part number HL53101 from Husky Liners; the exact contour custom auto floor liners on our 2009 Chevrolet Silverado. .
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Today, in this 2009 Chevrolet Silverado Crew Cab, we're going to show you the Weathertech Front Auto Floor Mats, part number WT460661 in gray. We're looking at the driver's side here and we have it laying in place. We're going to take a look at the edges here. First off, take a look, it actually covers the carpeting and your threshold and covering up the crack right there. If anything gets wet on the floor liner, worst case it has to go over a couple of edges first and then over your threshold. We'll go ahead and continue on. If we look by the kick panel, you can see how it raises up and protects that.
Today on this 2014 Chevrolet Silverado 1500 Double Cab, we're going to show you the Husky Liners X-act Contour Custom Auto Floor Liner for the 2nd row, part number HL53221. We got it installed in our truck here, which there's not much to it. Basically, you just lay it in place. However, you do want to make sure that you have any original floor mats or liners completely out of the way, because this is designed to work with the carpet itself. If we take a quick look under here, you can see the points on here called nibs, they actually grip the carpet to keep it in place and so it won't move around. Back to the topside, first off you can see a ridge along the edge here. You can see how it also overlaps the threshold between the carpeting and the plastic threshold. Anything that's wet in here and drains will stay in the liner and not get into your carpet. Of course, you've also got these ridges in here so anything that's on your shoes that's dripping off will go into your ridges here, and your shoes will dry off a little bit. This raised edge is at an angle going up towards the front.
Today on our 2012 Chevrolet Silverado Extended Cab, we are going to install part number L1CH01811509. This is 3D Kagu Custom Auto Floor Liners with max spider grip from U Ace. There is not much to our install however you want to make sure you want to remove any pre-existing floor mats or liners since our liners are designed to work with the carpet. We'll start on our driver side, lets go ahead and get it ready and let's go ahead and install our new floor liner. Let's go ahead and pat it into place. First off, you can see how it matches the contour floor right here.
Today on our 2013 Chevrolet Silverado we'll be test fitting the Husky Liners Classic Custom Auto Floor Liners for the rear in black, part number HL61521. These mats are also available in gray as part number HL61522. We'll begin our test fit by first removing the factory, or previously installed, floor mats. To do this, we'll simply curl in both ends to pull out the mat. We're now ready to place in our new Husky Liners Mat. Now, since this floor mat does cover underneath the rear seats, we will need to fold up the two pieces of the rear seats. We'll place the new mat into position, noticing the custom fit and extra coverage underneath the seats. There are raised channels here on the edges that you can see that will prevent liquids from falling over and damaging your carpet. The rubberized thermoplastic material won't crack or break and it withstands most hazardous chemicals such as oil, gas, and battery acid. The stay-put nibs here on the underside of the mat help to keep the mat in place. I'ts made in the USA and comes with a limited lifetime warranty. These mats are easy to care for.
Today in this 2002 Chevrolet Silverado extended cab we're going to review floor mats from Pilot automotive. Part number FM-310. We're going to start off on our driver side. We'll go ahead and remove the pre-existing floor mat and get it out of the way. We want to get down to the original carpeting. We'll take our new floor liner from Bully and lay it into place.
All right. Today, on this 2009 Chevrolet Silverado Extended Cab, we're going to install part number L1CH01811509, a 3D Kagu Custom Auto Floor Liners with MAXpider Grip. To start off, we need to make sure we get down to the bare carpet on our truck, so we'll go ahead and remove any pre-existing mats or liners. Then, we can go ahead and install our new liners into place. Starting on our driver's side, go ahead and lay it down and work it underneath the pedals. Okay. Once we have it in place, you can see how it matches the contour along the front of the seat.