Today on our 2003 Ford F-250 Super Duty, we're going to be installing the Edge Performance products dash pod adapter, part number EP98003. We already have the dash pod installed upon our dash. It's designed to work with the older Edge Evolution programmers. However, on this truck we have an Edge CTS. So well need to use this adapter to adapt the CTS or even the CS models to our currently installed dash pod. Next, well take the adapter and slide it onto the back of our Edge CTS or CS programmer.
Well plug the cable into the back of our programmer and using the adapter, well snap it into our dash pod. With that done, our Edge Evolution CTS is now mounted to our dash pod. That's it for the install of the Edge Performance products dash pod adapter, part number EP98003, on our 2003 Ford F-250 Super Duty.
Edge Insight CTS Gauge Display Installation - 2006 Ford F-250
Today in our 2006 Ford F250 Diesel, we're going to be installing the Edge insight CTS comprehension gauge display system, Part # EP83830. The first thing we need to do is locate our OBD 2 port. Next, we can mount our display up on our windshield where we want it. We'll use the alcohol wipe to clean the glass before we attach the suction cup mount. With the glass clean we can go ahead and secure our suction cup mount. Next we'll connect our cable to the back of the CTS monitor.
Edge Dash Pod Installation - 2003 Ford F-250
Today on this 2003 Ford F250 Super Duty, we're going to be installing the Edge Performance Products Dash Pod Mount for Edge Tuners, part number EP18300. The first thing we need to do is take our Dash Mount Pod and set it up on top of our dash and figure out where it's going to be placed. Once we have it in position, we'll use some masking tape to tape around it to indicate where we need to reset it when we go to adhere it later. With our mount in position, we'll take some more tape and secure it to our dash temporarily. We'll get the brackets that came with the kit, and make sure that they are angled properly to fit the contours of the pod as well as our dash. We're going to mark the indentations on the inside on the inside of our pod so that we can see them a little bit easier.
