Today on our 2012 Toyota Sequoia, we'll be test-fitting the Curt 20x60 Folding Aluminum Cargo Carrier, part number C18100. Now to begin our test-fit, we'll simply slide the cargo carrier shank into the hitch, line up the hitch pin hole, and install our hitch pin. Now that our cargo carrier is secured to the vehicle, we'll go ahead and give you a few measurements. From the closest point of the cargo carrier to the back of the vehicle is two and a half inches, and our ground clearance of this cargo carrier is 18 inches. Now, we'll go ahead and pull the pin on the cargo carrier to fold the carrier down. And we'll give you a few more measurements.
With the cargo carrier platform folded down, from the closest point of the cargo carrier to the back of the vehicle is 9 inches, and the cargo carrier will add an additional 28 and a half inches of over-all length, to the vehicle. Now the exhaust from this vehicle does exit the passenger rear, so there will be some heat transfer as you're driving down the road. And that completes our test-fit of the Curt 20x60 Folding Aluminum Cargo Carrier, part number C18100, on our 2012 Toyota Sequoia.
UWS Aluminum Cargo Carrier Review - 2012 Toyota Sequoia
Today on our 2012 Toyota Sequoia we'll be test fitting the 23 by 51 Aluminum cargo carrier for two-inch hitches, part number UWS03511. Now to begin our test fit we'll simply slide the cargo carrier shank into the hitch, line up the hitch pinhole and install our hitch pin and that will secure our carrier to the vehicle. Now we'll go ahead and give you a few measurements. From the closest point of the cargo carrier to the bumper of the vehicle is 4-1/2 inches and this cargo carrier will add an additional 27-1/4 inches to the overall vehicle length. Now the exhaust exits the passenger rear on this vehicle and is approximately six inches from the cargo carrier platform. It also appears to be about two inches lower than the platform so there will be little to no heat transfer while you are driving down the road and that completes our test fit of the 23 by 51 Aluminum cargo carrier for two-inch hitches, part number UWS03511 on our 2012 Toyota Sequoia..
Curt Hitch Cargo Carrier Review - 2012 Toyota Sequoia
Today on our 2012 Toyota Sequoia well be test fitting the Curt 20x48 cargo carrier for both 1 and 2 inch hitches part #: C18145. Now to begin our test fit well simply slide the cargo carrier shank into the hitch using the included adapter for the 2 inch hitch. With it in place well go ahead and install our anti-rattle bolt tightening it down. With the bolt tight our cargo carrier is secured to the vehicle. Now well go ahead and give you a few measurements. The closest point of the cargo carrier is 4 inches from the bumper and the cargo carrier will add an additional 2 feet to the overall length of your vehicle.
Surco Folding Hitch Cargo Carrier Review - 2012 Toyota Sequoia
Today on our 2012 Toyota Sequoia, we'll be test fitting part number 52018F, the Surco 24x60 folding cargo carrier for two-inch hitches. To begin our test-fit, we'll simply slide the cargo carrier shank into the hitch, line up the hitch pin hole, and install our hitch pin. And that will secure our cargo carrier to the vehicle. Now, we'll go ahead and give you a few measurements. Our ground clearance with this cargo carrier is 17 inches, and from the closest point of the cargo carrier in the stored position to the back of the vehicle is four inches. We can now pull the pin on the cargo carrier to bring the platform down.
