Today, we'll be using Chevy Silverado for test-fit of our Long View, original costumed towing mirrors that are slide on, part number ctm1600. To begin with, you will notice that each of the mirror housings have sections of foam as well of a felt pad inside, to help eliminate any scratching of your factory mirrors. As you will notice on the mirrors, there is a little LH or RH stamped on the inside. The LH is for the left hand side, or driver side, and the RH is for the passenger side.We will start with the driver side. It is helpful if you take the bracket, and slide it through the back of the mirror first before putting it over the factory mirror. Once you slide this in place, you will take the L shape bracket, and slide it over, and put an in cap on it.
Today, on our 2011 Chevrolet Silverado, well be testing K-Source Custom Towing Mirrors, part number KS80900. Now, these custom towing mirrors snap into place, fitting over the factory mirrors, offering you an expanded field of vision. The built-in mounting clips grab the inside edges of your factory mirrors for a simple, tool-free installation, with a clean look. Now, here on the drivers side, take our mirror and starting here on the top of our factory mirror, well clip it in, slide it down, allowing it to snap into place here on the bottom side of our factory mirror. With that, our mirror is on. Now, this mirror is manually adjustable.
Today on this 2013 Chevrolet Silverado, were going to do a test fit of part number CTM1600. Well work on the passenger side and well go ahead and slide the mirror over the factory mirror. Well slide it into place and push it on as far as possible. There is some foam inside the towing mirror, so itll compress a little bit as you push it in. Now well install the hardware to hold it in place. Well put the hook the goes into the front of the mirror with the round disc and then the L shaped bracket thatll help the fasteners go around the 90 degree turn and then well install the knob on the other side and then well install the hook to the other side of the 90 degree angle and install the knob onto it.Leaving this all loose in place, well go ahead and push it around and catch the inside edge of the mirror. When our things are hooked up we can go ahead and tighten it down, it usually only takes a few turns after that.
Today on this 2012 Chevrolet Silverado were going to do a test fit of part number CTM1600, custom towing mirrors from Longview. This part number does include two mirrors. Today were going to work with the passenger side. We have parts laid out. We have a mirror and our attachment hardware. The first step is to go ahead and slide our towing mirror into place, and then well install our hardware.
All right today on this 2013 Chevrolet Silverado, we're going to do a test fit of part number 10902 from CIPA. This is our CIPA Custom Towing Mirror for the passenger's side. We'll take the new towing mirror and slide it over the existing factory mirror. We'll slide it on part of the way and then install the wedge. The wedge goes between the new mirror and the old mirror. All right, and then we'll install the knob that locks everything down.