Today we are going to show you an American Flag Waving 2-Inch Hitch Receiver Cover, from Alfred. And this is part number 034092100201. As you can see here, it depicts an American flag in a waving position. And this fits only 2-inch receiver hitches. And it is constructed out of alloy material with an enamel inlay into the etching here to provide the colors. On the backside here, you can see the actual alloy material that it is made out of. It also comes with a gasket. What that does, it helps seal up the hitch tube cover and also provides a little bit of friction or something to press against for the wire forms as they are installed into the receiver hitch itself. And the wire forms themselves have two different lengths to facilitate installing a hitch cover, because sometimes a hitch pin in the end of the hitch itself has varying lengths, depending on that manufacturer. And on the tabs here, you can see that the pins have different heights, like say this one is towards the end and this one is towards the bottom. Again, it gives you better adjustment to make a proper fit on your hitch.
We will go ahead and install it on a 2-inch receiver hitch and show you what it looks like. We will show you how it gets installed. The wire form goes in and it touches the corners of the hitch and then press in and then slide your pin through. As you can see here, we use a 2-inch receiver pin, a standard one. Also, you can use a locking hitch pin too. Alright, and that covers our review of part number 034092100201.