We are going to be installing WeatherTech side window deflectors, part number WT80503. So, I am going to start by installing it here at the front, making sure that this piece is on the outside. We are going to the recessed areas and these are in channel visors. So we want the top sections, the thinned out portion, to go ahead and to sit inside the channel. And then with the front corner ed, we just actually want to go to t he rear section of the air deflector. When it is just sitting on top, it actually overlaps the door quite a bit. So what we are going to have to do is actually fold it down so that it can be ed into the channel. You can see there is quite a bit of flex in t he window visor. You want to make sure that you are not installing this in any weather that is under 50 degrees because that bending of the visor could actually crack the visor if it is not warm enough. 0:47
OK, I am going to set it about 1/2 inch to 3/4 of an inch down. And we will go back to the front section and go ahead and start ing it inside the channel. Just follow that all of the way to the rear and then we will go ahead and install the rear piece up into the channel. And that is all there is to it. You can see it makes a nice, tight streamlined look that contours perfectly with the vehicle doors. We just want to do the same thing for the passenger side visor. It is a good idea to go ahead and roll the window up once you have it installed and leave it there for about 24 hours. That is going to allow the visor to set and form fit around your window. And that will conclude the install of the WeatherTech side window deflectors, part number WT80503.
Putco Window Visors Installation - 2012 Dodge Ram
Today on our 2012 Dodge Quad cab Pickup well be installing the Putco element window channel visors, part number P580137. Starting here on the passenger side well go ahead and lower the window. We can go ahead and remove the adhesive cover. Starting next to the mirror down at the bottom near the window opening well put the visor into the window channel. Well go ahead and flex the visor so that we can get the opposite in into the window channel and then work the center into the window channel. Be advised that if the adhesive catches the window trim that youll need to go ahead and slide a flat bladed screwdriver or a trim panel tool in so that the window visor gets all the way up into the window channel.
Putco Window Visor Installation - 2009 Dodge Ram
Today we are going to install part number P580178 from Putco, and we are going to install this on a 2009 Dodge Ram full-size pickup. These vent visors will install in the channel with the window, and these will actually have a little bit of adhesive on them to help them stick to the inside of the channel of the door itself. The track that the vent visor fits into is right here, all the way down. And what happens is that the adhesive on the vent visor itself will actually attach to this inside edge on top up here, inside this edge right here. So before you peel the backing off the adhesive, it is a good idea to always do a test of it first. So let us put it right in the channel and just pop it into place. Then you have a good idea of where the adhesive sticks onto the weatherstripping here.
