Today, we're going to take a quick look at Titan's 5 on 4-1/2 Complete Hub and Drum Assembly, part number T1554500042. This assembly is designed to work with hydraulic trailer brake applications. It's got a 5 on 4-1/2 bolt pattern. There are five studs and if we measure from the center of one to the center of the next, we get 2-5/8, which means we have a 5 on 4-1/2 pattern. Included with the hub and drum are the races which were already pressed in the main bore. You also get five conical lug nuts, a grease seal, your inner and outer bearings, and finally, your cap for the end.
We'll take a quick measurement inside. We have a depth measurement of about 2-1/2 inches. Across the diameter, we get 10 inches. With those measurements, we know that we should be using 10 by 10-1/4 brake assemblies. And finally, Titan does cover this hub and drum assembly with a one-year warranty.
And that's it for our quick look at Titan's 5 on 4-1/2 Complete Hub and Drum Assembly, part number T1554500042.
Cleaning and Replacing Hubs and Bearings
First off we will go ahead and take off the dust cap. In this case it is a bearing buddy. Next is taking out the locking pin, the cotter pin that goes through the center here. Once you have that lock washer off, just go ahead and take off the nut and pull your whole hub off. Now we are going to go ahead and inspect the hub and bearings here.
Remove and Reinstall a Trailer Hub Review
First off, we will take off the hub, then take off the nut on the inside, and we will pop the whole hub off and take it to the workbench and clean it up from there. You can see there is a lot of rust in there, there is a lot of condensation. Basically water got in there through either condensation or a seal leak. We definitely need to take it apart and clean it up. This has whats called a tang washer. Instead of a regular cotter pin that goes up and down, it has a little piece of metal that goes between the notches here and you have to push this back, flat, so you can take off the nut. And the whole thing just slides off. Sometimes if it gets caught on the hub here you can beat it to get it to come loose. We will go ahead and clean this spindle off here, and then we will put our hub back on. Give it a test fit first to make sure it all slides on pretty good and then go ahead and take it back off. What is good is to take a thin layer, it doesnt have to be much just a little bit, to kind of help the parts slide on a little bit more than they used to.
Trailer Hub Inspection Demonstration
We get many many questions on how to make sure trailer hubs and brakes are safe for travel. Here Joe addresses some of those questions demonstrating how to thoroughly inspect the hubs, breaks and bearings. I know many of us take the performance of these assemblies for granted but if you are planning a long trip or just make short trips around town you should be aware of their condition. I like to say it is time well spent when it avoids break downs on the side of the highway.
