2007 Toyota Tacoma Camper Tie-Downs

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've…

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for…

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

Hey Robert, sorry it can be a bit confusing navigating all those facets for the camper tie downs, but I did go ahead and find those tie downs you were looking for. For the front, you'll want the…

The primary advantage of frame-mounted camper tie-downs like the TorkLift #TLF2012A and #TLF3001A, which are designed to fit your Ford F-350 if it has the 6-3/4 foot bed without a step/board underneath and a factory hitch, is the stability they…

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

Hey Mark, thanks for the question, and while we have exactly what you're looking for, it's actually a different part number (the one you mentioned is for a long…

The aluminum TorkLift Talon Camper Tie-Downs #TL94FR that would fit your 2022 Ram 2500 will not fit with the running boards that you have. With how these mount the running boards have to end with the cab and can not extend past it at all. If you…

Your slide-in truck camper does not have electric brakes so the blue brake circuit wire from its 7-way connector is not used. All other lighting functions as well as 12V auxiliary power will be maintained on the other circuits. Please refer to the…

Of the two part numbers you mentioned only the #TLF2022A is a fit for your 2022 Ford F-350 short bed without factory board and with the factory installed hitch. You might have meant to type #TLF2022 which is the non-aluminum/stainless steel option…

That's a good question Mark, and yeah I agree, it would make sense for the screws to be on the bottom when using the Gen-Y Anti-Rattle Clamp for 2-1/2" Hitch…

The Brophy Clamp On Camper Tie-Downs #HSSF will have a very slight amount of play since there is a compressible pad to prevent scratches on the bedrails, but it sounds like you're having much more…