Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Yes, the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will fit your 2024 Chevrolet Silverado 3500 High Country. The Firestone Air Command #F2097 will allow you to easily adjust and monitor the air pressure in your air springs…
view full answer...I do have a way for you to install a 7-way trailer connector on your 2012 Ford F-150 but the plug in the photo you attached does not have all of the circuits needed for a 7-way trailer connector so there is not one that plugs directly into this.…
view full answer...There is not a torque spec on the axle nut for the Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 #84545BX. The axle will have a castle nut that should be tightened until there is no side to side play and then backed off to the…
view full answer...Yes, the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver part #41990-16 is exactly what you are looking for as it has very tall side brackets which will be more than enough to get the receiver tube down under the rear bumper, adjustable…
view full answer...I may have another option for you, but the Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2" #c14006 you mentioned is only confirmed to fit select 2014-2019 GMC/Chevrolet 1500 trucks and will not fit your 2006 Chevrolet W-3500 or 2006…
view full answer...If the brake magnet is worn to the point that the windings are visible then you know it's time to replace the magnet. However, magnets can also fail without the visible signs of wear. Check out the FAQ article I attached on testing brake magnets…
view full answer...It looks like a Hayes Brake magnet part number 73400. We do not carry this part but I did a quick internet search and was able to find a couple places that sell them. From the research I did it looks like this is an older style of brake magnet used…
view full answer...The Buyers Products Flatbed/Flatbed Dump Hitch Plate Bumper with 2" Receiver #3371809055 is designed or flatbeds and flatbed dump trucks. While it is ready to mount on Ford trucks, there is some drilling required for GM trucks. This hitch is a…
view full answer...The pintle hook mount that I would recommend for you is the Pintle Hook Mount, 12-1/2 inch Tall, 8K, part #63058. This hook mount has an adjustable rise that will go up to a 12 inches. That would put the height of your pintle hook mount right at 31…
view full answer...The difference between a D15 tire and an R15 tire is the construction. The D denotes that it's a bias tire and the R is for a radial tire. Which is best for you depends on the type of terrain you're towing the trailer on because bias tires…
view full answer...The depth of the channel of the Demco 6-Hole Adjustable Channel Bracket #DM66134 is 2-1/8 inches. This is a standard depth for this type of channel.
view full answer...I can tell you what Curt lists as the capacities for their #15901 and #15902 hitches. You are correct, they both have 12k capacities. The only other capacity you will need to look up is the capacity for your RV. If it is at least 12k then you could…
view full answer...Filter Your Search