Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Fifth Wheel Trailer King Pin #337KP20050 is 2 inches diameter where the jaws of the 5th wheel hitch will connect. Typically the max wear on a king pin is .080 of an inch with a minimum diameter of 1.920 before manufacturers recommend…
view full answer...The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…
view full answer...It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
view full answer...To add a 2" hitch to your 2023 Kia Soul, I recommend the Draw-Tite Trailer Hitch item #DT25GR. This hitch is custom fit and bolts to your Kia with included hardware. It will not fit the 1.6L Turbo model. I really like this hitch because…
view full answer...One The Kenda Tire/Wheel combo we offer that is a 205/65-10 tire is part #AM3H440. The correct psi for this combo is1,330 lbs at 70 psi. You should always inflate your tires when they are cold. At the maximum air pressure, the tires will perform and…
view full answer...Thank you for your purchase of the Kenda 205/65-10 Bias Trailer Tire with 10" Galvanized Wheel #AM3H440. We recommend using the PSI rating of 70 which is listed on the sidewall of the tire. Some tire manufacturers have a progression chart…
view full answer...The wires on the Dexter Nev-R-Adjust Electric Trailer Brake Assembly #K23-478-00 are 12 gauge wires. We recommend using 10 Gauge Wire #10-1-1 from the trailer 7-Way connector to the brakes though to help ensure enough power gets to them.
view full answer...The magnet wires are brake assembly #23-468 are 16 gauge. When it comes to wiring for electric trailer brake magnets you can attach a larger gauge wire to the smaller brake magnet wire. Ten gauge wire is commonly used in trailer manufacturing for…
view full answer...The bent grease zerk is a concern for being able to add grease. From your photo, I can't tell if it was the correct manufacturer angle or if it has been bent. I've attached a photo of the manufacturer bend angle to help. It looks like they…
view full answer...As long as your existing hub drums are in good condition (no grooves worn in the armature surface that the brake magnet rides on or the surface that the pads grab). For a lot of trailer hub/drums there is a minimum thickness for that to be turned…
view full answer...We do have replacements for the specs you're asking about. The kit you're looking for comes from CE Smith: - CE Smith U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles #CE23002 This kit comes with the U-Bolts, mounting brackets, and the…
view full answer...For 1/2 inch trailer u-bolts that attach to axle the recommended torque value is between 45 and 70 ft lbs of torque.
view full answer...Filter Your Search
Contact and Help