Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
For a brake controller I would recommend the Prodigy P2 Brake Controller part #90885 for your 2013 Subaru Outback Wagon. This is our best selling brake controller because of how well it works and how easy it is to setup. Since you do not have a…
view full answer...The curve in the Malone Anti-Rattle HitchLock System part #MPG908 is designed for extra stability to not allow the shank of the accessory to move up and down. It is what holds the shank of accessory tight. I have attached a photo of how this is…
view full answer...Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball…
view full answer...To flat tow your Jeep Wrangler JK behind your motorhome, you will need a base plate kit, tow bar, safety cables, tail light wiring harness, and a supplemental braking system. Depending on the year of your Wrangler, you may also need a Brake-Lite…
view full answer...To complete the installation of T-One Vehicle Wiring Harness, part #118520, there is normally a grommet located close to the installation point that can be used, it is normally at the bottom of trunk cargo area. You would want to cut a small slit in…
view full answer...Yes, you will need to run separate wiring for both connectors. You will need to install the wiring for the 4-pin connector, part #118305, with its own power wire to the battery. Then, you will need to install the wiring for the 7-pin connector, part…
view full answer...In regards to the Adjustable Width Trailer Hitch Receiver for RVs part #13703, the brackets have a built-in offset so you can install them in a manor which pushes the crosstube further out towards the bumper. This will help reduce clearance issues…
view full answer...You're right that the Inno Ridge Rooftop Cargo Box - 8 cu ft - Gloss Black #INBRA220R-BK is contoured to sit lower around past the crossbars. This is for a more aerodynamic shape to cause less drag. Because of the way this cargo box mounts and…
view full answer...I went out into our showroom and measured the dimensions of a set of discontinued Thule square load bars and found that they are 7/8 of an inch by 1-1/4 inches. This is identical to the Inno square bars like #INB137.
view full answer...The Thule Podium 460 you referenced for old square bars has been discontinued so that is why the expert answers suggest using the Evo Fixpoint Feet #TH49SC for use with the new Thule SquareBar that have a slot in the bottom like the aero style bars.…
view full answer...You can certainly replace your 2013 Subaru Outback's factory hitch with a larger 2 inch hitch like the Draw-Tite #75673 so long as your Outback is not a Sport model. I reached out to the manufacturer to try and find out if the Draw-Tite would fit…
view full answer...I do have an option for you but the Toyota Tacoma has an extra large receiver sleeve which can cause issues with certain hitch pins as you have come to find out. I don't have a longer hitch pin for the Yakima HoldUp but we do have a way for you…
view full answer...Filter Your Search
Contact and Help