Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I have attached a photo of what I believe you have on your John Deere Tractor. If that is the case then this is what is referred to as a 7-pole trailer wiring harness and in order to then adapt this for use with a 7-blade trailer connector you…
view full answer...The Draw-Tite Max-Frame Trailer Hitch Receiver #75282 will have the following bolt hole dimensions for your 2015 Nissan Frontier. The Bolt holes from drivers side to passenger side frame rails are 43-5/8" on center. The holes running from…
view full answer...My recommendation for your application is to use the Dexter Single-Axle Trailer Hanger Kit for 2-1/2" Slipper Springs - 5-1/4" Front #HAP-158-00. This can be used with the 10K GD Spring Eye Bolt w/ Grease Zerk #7-135-2 and Locknut…
view full answer...For the right hand side 18-3/8 inch long equalizer for 2-1/2 inch wide slipper springs you can use #13-140-3. It can actually be used as a left or a right.
view full answer...I attached a picture that shows how the Ultra Faucets Single Handle Tub and Shower Diverter #277-000024 normally gets installed and used in a shower. It is designed to be used with a shower head and handle but not to fill a tub. The Phoenix Faucets…
view full answer...Yes, and no. If you plan on using the Blue Ox Patriot Radio Frequency, Portable Braking System item #BLU37TR, you were looking at, you will also need the Roadmaster Brake-Lite Relay Kit for Towed Vehicles item #RM-88400. It will keep your…
view full answer...When installing the MORryde Quick Connect RV Steps #MR85HR, there is not a set way to ensure the screws are not hitting anything such as wiring. That being said, the MORryde Quick Connect RV Steps #MR85HR do not use lag bolts for installation. There…
view full answer...For the etrailer D-Ring Tie Down Anchor #RRING-Q6000 you will need to use the Backing Plate #BP05. This will increase surface area for the bolts used to attach the anchor to your floor giving it additional support. I included a video of the…
view full answer...A shorter hook would help with the angle of the door to help get the hook into the holder for your trailer's door. An option with a 45 degree bend in it, like the part #37211765, would give you a better option to work with the angle of the door,…
view full answer...Wheel bolt patterns are defined by two numbers: the first being the number of lug nuts and the second being the diameter of the circle the lug nuts are arranged in. So a 5 on 4-1/2 bolt pattern is 5 lugs arranged in a circle that is 4-1/2 inches in…
view full answer...That would depend on several different factors such how much the door sticks out away from the trailer and how much the handle sticks out away from the door. However, if you do run into clearance issues you can always install a spacer on the hinge…
view full answer...The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…
view full answer...Filter Your Search
Contact and Help