These multipurpose, galvanized steel crossbars supply the backbone for your aftermarket roof-rack system. Bars provide stability to your rack system and carry the accessories that secure your gear. Round design fits all Yakima towers.
Installation Notes:
When open, sunroof may interfere with some accessories
Caution! Check clips after installing. Grab each clip and try to pull them hard away from your vehicle. If the clip moves, tighten the adjustment post. If the clip still moves, recheck your measurements between the towers and adjust if necessary. Check clip again
Round 48" CrossBars for Yakima Roof Rack System (QTY 2)
Yakima RailGrab Towers for Flat and Raised Side Rails (QTY 4)
Roof Rack Specs:
Crossbars Round Bars Black 48 Inch Long 2 Bars
Steel Locks Not Included
Capacity 150 lbs
Crossbar Spread 31 inch
Features:
These multipurpose, galvanized steel crossbars supply the backbone for your aftermarket roof-rack system. Bars provide stability to your rack system and carry the accessories that secure your gear. Round design fits all Yakima towers.
Installation Notes:
Any load extending over the windshield (except luggage boxes) must be secured to both the front and rear of the vehicle, in addition to the rack. The total weight of the racks and loads must not exceed Yakima's weight limit for that vehicle's factory rack
Check your vehicle before purchasing this product. Some models may not be equipped with factory crossbars
Boa bike mount will not work due to crossbar spread limitations