Free Shipping on Orders Over $99
Complete Kit Includes:
Roof Rack Specs:
Black, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your vehicle with a naked roof. These strong, durable, Euro-style square bars install easily and work with most clamp-on accessories.
This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.
Application excludes vehicle equipped with a panoramic sunroof.
Aerodynamic, aluminum crossbars let you build an aftermarket roof rack for your vehicle. Full-length bars provide plenty of space for carriers and accessories. Vortex strips in C-channels reduce wind noise. Theft-deterring plastic locks included.
These multipurpose, galvanized steel crossbars supply the backbone for your aftermarket roof-rack system. Bars provide stability to your rack system and carry the accessories that secure your gear. Round design fits all Yakima towers.
Caution! Proper tower balance is critical for this installation. Pay close attention to the gold slider positions and increase micro adjuster in small increments, alternating between towers until the sliders are at equal levels in relation to the hash marks on the towers. Slider positions may not be equal from one bar to the next
Press firmly against the lower portion of the clip while tightening the rack. This will properly locate the clip over the internal raingutter
Any load extending over the windshield (except luggage boxes) must be secured to both the front and rear of the vehicle, in addition to the rack. The total weight of the racks and loads must not exceed Yakima's weight limit for that vehicle's factory rack
Caution! Check clips after installing. Grab each clip and try to pull them hard away from your vehicle. If the clip moves, tighten the adjustment post. If the clip still moves, recheck your measurements between the towers and adjust if necessary. Check clip again
Any load/mount extending beyond the rear hatch seam may cause interference
This fit requires the use of Q-Tower #Y00124. Reference the image link above to confirm your Q-Towers. Contact customer service if you have questions
Boa bike mount will not work due to crossbar spread limitations
These steel, square crossbars attach to Inno feet to create a sturdy roof rack for your vehicle. Elastomer coating resists corrosion and helps cushion your load. Bars accommodate carriers and accessories that clamp around bars.
This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof
These heavy-duty, aluminum crossbars work with Rhino-Rack legs to create a sturdy roof rack or ladder rack for your vehicle. The square bars have built-in C-channels for mounting Rhino-Rack Heavy-Duty, contractor-grade accessories.
These heavy-duty, aluminum crossbars work with Rhino-Rack legs to create a sturdy roof rack or ladder rack. The square bars include built-in C-channels for mounting Rhino-Rack Heavy-Duty, contractor-grade accessories.
This quiet, aerodynamic roof rack with a from-the-factory look lets you carry gear on your vehicle's naked roof. Sturdy, lightweight aluminum crossbars include top channels with noise-reducing Vortex strips. Integrated locks deter theft.
Low-profile, aerodynamic crossbars create an aftermarket roof rack for your vehicle. Aluminum bars have T-slots that let you mount channel-mounted carriers and accessories. Flexible rubber strips in T-slots keep out dirt and won't need trimming.
INXB108 is designated to be the frontmost bar while INXB100 is the rear
Custom Fit Accessories For Your2012 Chevrolet Volt
2012 Chevrolet Volt Trailer Hitch
2012 Chevrolet Volt Trailer Wiring
2012 Chevrolet Volt Brake Controller
2012 Chevrolet Volt Roof Rack
2012 Chevrolet Volt Trunk Bike Rack
2012 Chevrolet Volt Suspension Enhancement
2012 Chevrolet Volt Performance Chip Tuners
2012 Chevrolet Volt Exterior Lights
2012 Chevrolet Volt Tire Chains
2012 Chevrolet Volt Floor Mats
2012 Chevrolet Volt Vehicle Covers
2012 Chevrolet Volt Side Window Vents
2012 Chevrolet Volt Lamp Guards
2012 Chevrolet Volt Vehicle Seat Covers
2012 Chevrolet Volt Windshield Wiper Blades
Popular Chevrolet Volt Accessories
Filter Products (10)
Contact and Help
What our customers are saying:
Thanks, I got it and it only took about 20 minutes to install. Marty
Fairview Park, OH
Subscribe to email newsletter
privacy - we don't send unsolicited email
All images, layout and content copyright etrailer.com