2011 Chevrolet Traverse Roof Racks

Features:

These multipurpose, galvanized steel crossbars supply the backbone for your aftermarket roof-rack system. Bars provide stability to your rack system and carry the accessories that secure your gear. Round design fits all Yakima towers.

Installation Notes:

When open, sunroof may interfere with some accessories

Caution! Proper tower balance is critical for this installation. Pay close attention to the gold slider positions and increase micro adjuster in small increments, alternating between towers until the sliders are at equal levels in relation to the hash marks on the towers. Slider positions may not be equal from one bar to the next

The rubber/chrome door seals and/or trim may deform or be damaged under prolonged contact with any roof rack towers and/or clips. Remove rack when not in use

Caution! Check clips after installing. Grab each clip and try to pull them hard away from your vehicle. If the clip moves, tighten the adjustment post. If the clip still moves, recheck your measurements between the towers and adjust if necessary. Check clip again

The factory crossbars must be removed with a Phillips screwdriver

Rear hatch will interfere with some accessories. Use caution when opening

This fit requires the use of Q-Tower #Y00124.  Reference the image link above to confirm your Q-Towers. Contact customer service if you have questions

This kit fits over factory racks

Features:

Black, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your naked roof. Elliptical bars are aerodynamic and feature built-in channels to accept slot-mounted and clamp-on accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Please note system fits over factory flush rails.

Features:

Black, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your vehicle with a naked roof. These strong, durable, Euro-style square bars install easily and work with most clamp-on accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Please note system fits over factory flush rails.

Features:

Silver, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your naked roof. Elliptical bars are aerodynamic and feature built-in channels to accept slot-mounted and clamp-on accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Please note system fits over factory flush rails.

Features:

Equip your vehicle with the quietest crossbar style on the market and carry a ton of cargo with the Whispbar Through Bar extended-length roof rack. The locking, aluminum bars mount with a custom fit kit, and they have built-in slots for accessories.

Installation Notes:

Any load extending over the windshield (except luggage boxes) must be secured to both the front and rear of the vehicle, in addition to the rack. The total weight of the racks and loads must not exceed Yakima's weight limit for that vehicle's factory rack

Any load/mount extending beyond the rear hatch seam may cause interference

Attaches to factory-fitted track.

Features:

The aerodynamic Whispbar Flush Bar pairs a factory look with the quietest crossbar style on the market to form the ultimate roof rack for your vehicle. These locking, aluminum bars mount with a custom fit kit and have built-in slots for accessories.

Installation Notes:

Any load extending over the windshield (except luggage boxes) must be secured to both the front and rear of the vehicle, in addition to the rack. The total weight of the racks and loads must not exceed Yakima's weight limit for that vehicle's factory rack

Any load/mount extending beyond the rear hatch seam may cause interference

Attaches to factory-fitted track.