Tekonsha Prodigy Showing PL, PL and SH Error Codes

Expert Reply:

First, lets start by resetting the Prodigy. With the trailer disconnected from the vehicle, disconnect the brake controller by unplugging the harness from the rear of the unit, and plug it back in. The display will show NC for 15 seconds, and then show two dots. The OL error code indicates that the Prodigy is drawing too much current. This is usually caused by a short on the brake output wire on the trailer or low resistance to ground on the brake wire. Look for any pinch points, or worn or cracked insulation that would allow the output wire to short out on the trailer frame. Check the ground leads that exit each brake assembly, make sure they are securely grounded to bare metal on the trailer frame. Make sure these grounding points are not corroded, as well. The PL code will be displayed when the Prodigy looses voltage on the black wire while either the brake pedal or the manual lever is being applied. This may be caused by a loose connection or I have also seen a faulty circuit breaker case this as well. The SH code can also be caused by a short on the output circuit.

expert reply by: Mike L