Question Was Asked By - Xavier W

Location of Brake Controller Installation Port on 2000 Ford Expedition XLT

Question:

I am looking to add a Brake controller to my 2000 Ford Expedition XLT. I see the Blue and Orange wires for the factory tow harness connection on the rear wireharness. However I cannot locate the tow package port located under the dash where I would plug the Brake controller into. I want to make sure I get the correct solution when I purchase this. Your assistance is very much appreciated.

asked by: Xavier W

Expert Reply:

The port should be located under the dash, near the steering column. It is in pretty close proximity to the diagnostic port. It sounds as if you might need a Brake Controller Wiring Adapter. If so, we offer them. The part # is 20260.

expert reply by: Mike L

Products Referenced in This Question

Universal Brake Control Wiring Adapter Ford, Land Rover, Lincoln, Mercury