Parts Needed to Convert a Separate Tail Light Signal of a Honda Goldwing to Combined for Towing
Question:
I have an 04 Goldwing with a 5 pin wiring harness and I need to adapt to a trailer with a 4 pin hookup. I have installed an adapter converting the 5 to a 4 however, the brake light does not function on the trailer. Everything else works great. How can I make the brake light function using the adapter or is this possible? Your help is appreciated.
asked by: Eddie O
Expert Reply:
It sounds like the adapter you used dropped the brake light circuit when it went from a 5-way to a 4-way. Normally on a 4-way the brake light circuit is on the turn signal circuit. Motorcycles usually have a separate wire/circuit for just the brake lights separate from the turn signals so I believe that is where your problem is from.
I believe I have a solution for you, but not with using the adapter you have.
I would recommend you cut off the 5-way on your motorcycle. Wire in a tail light converter kit part # HM48895. This will convert your separate circuit tail light signal of your motorcycle to a combined circuit like what your trailer has.
You will need a circuit tester like our part # 3808 to determine the functions of the connector on your motorcycle and then need to wire it by function to the circuits of the # HM48995.
I attached an FAQ on trailer wiring for you to check out also.
Products Referenced in This Question
Hopkins Tail Light Converter with 4-Way Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 6 Feet Long
- Universal Fit
- 4 Flat
- Hopkins
more information >
Product Page this Question was Asked From
Hopkins Wiring Harness with 5-Pole Flat Trailer Connector - Vehicle End - 5' Long
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 5 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Lighting and Wiring Options for Flat-Towing a Jeep Wrangler Behind a Motor Home
- Q&A: Converting A 6-Pole Trailer to 7-Pole Tow Vehicle Connection
- Article: Trailer Lighting Requirements
- Q&A: Troubleshooting Trailer Connection Getting HOT
- Article: Performance Chips and Modules
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Will 4-Way Connector of Wiring Harness # 118538 Fit Curt 4-Way Bracket # C58001
- Q&A: Recommended Suspension Enhancement For A 2023 Kia Telluride
- Q&A: What Is the Best Suspension Enhancement for My 2021 Jeep Wrangler Unlimited Rubicon
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes