Question:
I have a 2005 Toyota Camry that rides quite low.. Can you recommend a ball mount with a 4 or 5 inch rise that would be appropriate for my vehicle. Thank you.
asked by: Richard B
Expert Reply:
Because all of the trailer hitches for the 2005 Toyota Camry are Class II hitches, see link, you must use the ball mount specified by the trailer hitch manufacturer. Using a different ball mount voids the warranty because only the recommended ball mount has been tested and approved for each respective trailer hitch.
For a Draw-Tite or Hidden Hitch trailer hitch, use # 36061. It has a 3-1/8 inch rise measures from the top of the receiver opening on the hitch.
For the Curt hitch, the correct ball mount is # C45520. It also has a 3-1/8 inch rise.
expert reply by: Michael H
Products Referenced in This Question
Class II Drawbar 3-1/8" Rise (Kit)
Product Summary:
Fixed Ball Mount
Standard Ball Mount
Long
Steel
Product Specs:
Fits 1-1/4 Inch Hitch
Rise - 3-1/8 Inch
Class II
3500 lbs GTW
Curt Class II Drawbar - 3-1/8" Rise - 9-1/4" Long - 3,500 lbs
Product Summary:
Fixed Ball Mount
Standard Ball Mount
Solid Shank
Long
Steel
Product Specs:
Fits 1-1/4 Inch Hitch
Rise - 3-1/8 Inch
Class II
3500 lbs GTW
Product Page this Question was Asked From
Class II Drawbar 5" Rise (Kit)
Product Summary:
Fixed Ball Mount
Standard Ball Mount
Long
Steel
Product Specs:
Fits 1-1/4 Inch Hitch
Rise - 5 Inch
Class II
3500 lbs GTW
Can a Class II Ball Mount be Used with a Class I Trailer Hitch on a 2006 Mitsubishi Eclipse GTCan The Draw-Tite Ball Mount, # 36065, Be Turned Over And Used As A Drop On a Mercury MountaineerWhat is the recommended Draw Bar for a 1999 Cadillac DeVilleFeatured Help Information
Trailer Hitches for 2005 Toyota Camry
Draw-Tite Class II Drawbar 3-1/8 Rise Kit Review - Video
