Question:
I am not sure how to connect the new submersible trailer light. There is a plastic/rubber piece covering the connection of wires between the trailer and submersible light. How do you remove this? Should the new connection be covered with this rubber piece too? Thanks for your help!!
asked by: Heidi G
Expert Reply:
If you are referring to the little piece of wire insulation that is on the very end of the wire you will just need to grab that piece and slide it off. Check out the picture I attached to make sure we are talking about the same thing.
You will want to have the insulation of the wires stripped back so that the connections you make are metal to metal. Otherwise the light will not function.
I attached a review video for this product for you to check out also.
expert reply by: Jameson C
Have a question for the experts? click here.
Product Page this Question was Asked From
Wesbar Submersible Low Profile Trailer Tail Light (Right Side)
Product Summary:
Tail Lights
Submersible Lights
Red
Surface Mount
Product Specs:
Rectangle
Incandescent Light
8L x 2-7/8W Inch
Can a Trailer have a Mix of LED and Incandescent LightsDo the Wires of Wesbar Submersible Trailer Light Need to Be Stripped Back to InstallWiring the Wesbar Submersible Low Profile Trailer Tail Light Right Side # 403076 To A TrailerAvailability of Replacement Lenses for the Wesbar Submersible Low Profile Trailer Tail Light
Wesbar Submersible Low Profile Trailer Tail Light Review - Video
