Question Was Asked By - Jim S

Connecting a Modulite on a 2008 Toyota RAV4

Featured Help Information

Question:

Hello: I need to hook the hot wire of the wiring harness you just shipped me for the 2008 RAV4 in to the connector block under the instrument panel. How? Where? Which fuse? The vehicle supposedly has the tow prep package, but that evidently does not include a +12V wire to the rear quarter panel. I already have run a 15A wire to the dashboard. Ive seen the Toyota factory wiring harness, but it has no diagram of where to hook in. Thanks

asked by: Jim S

Expert Reply:

The 12V feed for your T-One Vehicle Wiring Harness should be run to the positive battery terminal, not the fuse box. The red lead that comes out of the converter box that has the butt connector on the end would connect to the black 12 gauge wire included with the T-1 Wiring Harness. This wire would run to the battery, using the provided 10 amp fuse holder. For reference, I'll include a copy of the installation instructions, which can be found by using the link found below.

expert reply by: Mike L

Products Referenced in This Question

T-One Vehicle Wiring Harness with 4 Pole Trailer Connector