Question:
Tongue jack is 2.25inch square and welded to frame. Nut stripped out, inner screw is ok, what is the O.D. of the screw inside of jack # PS1400850383?. Would like to just take bottom half of your jack for a replacement without having to cut the old jack off.
asked by: Dave H
Expert Reply:
I went out to the warehouse and took apart part of Pro Series jack, # PS1400850383. The screw inside was difficult to access but I was able to get a measurement of 3/4 inches at the threads and 1/2 inch at the top where the stem goes through the gear. I called my contact at Pro Series and he confirmed these measurements.
expert reply by: Michael H
Product Page this Question was Asked From
Pro Series Square Jack with Footplate - Drop Leg - Sidewind - 15" Lift - 8,000 lbs
Product Summary:
Drop Leg Jack
Sidewind Jack
With Foot
13-2/3 Inch Drop Leg
8000 lbs
Product Specs:
15 Inch Lift
Weld-On
Comparing Bulldog and Pro Series 8K Trailer JacksWhat are the Square Tubing and Foot Plate Dimensions of the Pro Series Square Jack # PS1400850383What is the Screw Diameter for Pro Series Trailer Jack # PS1400850383How do you Replace the Internal Housing and Foot Plate on the Pro Series Square Jack # PS1400850383Can the Pro Series Drop Leg Trailer Jack be Welded to an A-Frame TrailerFootplate Dimensions for the Pro Series Square Jack # PS1400850383Outer and Inner Tube Dimensions for the Pro Series Square Jack with Footplate # PS14000850383Can a Pro Series Square Drop Leg Jack with Footplate be Used as a Portable Jack On a 53 Ft TrailerDoes the Eclipse Square Jack with Footplate, # EC1400850376 Weld Directly to the Trailer FrameFeatured Help Information
