Question:
can it be mounted to the center of the trailer tongue through a flat metal plate?
asked by: Robert N
Expert Reply:
A metal plate can certainly be used. We offer # BDSPBQ50 that with some fabrication would work well for you. You would need to enlarge the 2-1/3 inch hole to 2-1/2, and weld one plate to the top of the trailer frame, and one to the bottom.
You would want to weld in the jack at a height so that when it is retracted, it will avoid any road debris but when extended, it would place the coupler high enough so that it can be placed on the trailer ball.
expert reply by: Mike L
Products Referenced in This Question
Bulldog Jack Support Plate - A-Frame - 2-1/3" Square Hole
Product Summary:
Trailer Jack
Replacement Parts
Product Specs:
Mounting Brackets
Support Plate
Product Page this Question was Asked From
Trailer Jack, Shelby Topwind Drop Leg Trailer Jack - 8,000 lbs.
Product Summary:
Drop Leg Jack
Topwind Jack
With Foot
14-1/2 Inch Drop Leg
8000 lbs
Product Specs:
28-1/2 Inch Lift
Weld-On
Featured Help Information
Can the Shelby Topwind Jack # 6108TW Be Welded to a Plate at the Center of the Trailer Tongue
