I have a 2011 Yukon XL without a wiring harness to hook up electric brake box. Looking for a wire kit and brake controller. Will this just plug in for me?
asked by: Jordan
No plug is present under the dash, but the wires are already run. You only need to connect the Tekonsha Prodigy P2 brake controller # 90885 wiring with the vehicle wiring already present under the dash.
The # 90885 is one of our best selling brake controllers because of how easy it is to setup and how well it works.
There is also a couple connections that need to be made under the hood of your vehicle. Check out the FAQ article I attached on installing a brake controller on a GM vehicle such as yours.
Once those wires are run you would be ready to go as long as you have a 7-way connector present at the rear of your vehicle. If you do not have a 7-way you will need a Multi-Tow 7-Way and 4-Way Trailer Connector # 30955.
expert reply by: Jameson C
Products Referenced in This Question
Trailer Hitch Wiring
For Vehicle w Factory Tow Package
Product Page this Question was Asked From
Electric over Hydraulic
2 - 8 Brakes