Quiet Electric Trailer Jack with Remote Operation for Use in Levitation Illusion  

There is no reason why you could not turn the jack at a 90 degree angle to gain more clearance. Due to the configuration of the holes in the mounting flange, you might need to drill new holes in your trailer tongue to mount the jack in that…

The Bulldog Powered Drive Trailer Jack part #BD500199 comes with an internal circuit breaker so there should not be a in-line fuse holder on the black wire from the jack unless someone added it during installation or before you purchased the jack…

I spoke with my contact at Bulldog, and he provided several possible causes for the problem you are experiencing. The jack grounds via its attachment point to the trailer. In case there is excessive paint between the jack and the trailer frame,…

Technically, your A-Frame Bulldog Powered Jack, Item #BD500199, can be powered by the 12 volt circuit on a 7-Way trailer side connector which is in the 1 o'clock position where the wires connect if looking at the back of the 7-Way connector.…

It sounds like you're saying it is hooked up to power but it doesn't have the ability to raise the trailer. This could be the batteries or a problem with the wiring. It is probably getting power, it just may not be enough to lift the trailer.…

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

That is correct. There is nothing to support the bumper when you install the Curt Hitch item #C15398 on a 2013 Toyota Tundra. That hitch was designed for the trucks without the factory hitch so there's no reason for it to have built in support…