I HAVE A 2010 JEEP WRANGLER WITH THE SPARE TIRE MOUNTED ON THE OUTSIDE.. WILL THIS ITEM FIT WITH THE TIRE IN PLACE?
asked by: RICK
To see if the Rola Hitch Cargo Carrier, # 59109, will fit on your 2010 Jeep Wrangler, first there are a few things you will need to check out on your hitch and your vehicle.
The Rola Hitch Cargo Carrier, # 59109, can only be used on Class III and Class IV 2 inch hitches. So you will want to check to make sure you have a Class III 2 inch hitch on your 2010 Jeep Wrangler. If you look on your hitch and it says 3,500 lbs towing capacity and 350 lb. tongue weight capacity then it will be a Class III hitch. The Jeep Wrangler will not use a Class IV hitch.
On your 2010 Jeep Wrangler with spare tire on the back you will need to measure the distance from the center of your hitch pin hole to the farthest back part of your spare tire. This measurement will determine if the cargo carrier will clear your spare tire.
The measurement on the Rola Hitch Cargo Carrier, # 59109, is 13 inches from the center of the hitch pin hole to the back edge of the carrier and 5 inches with the lid open. So if the measurement you took on your vehicle is less than 13 inches it will clear your spare tire with the lid closed. If the measurement on your vehicle is less than 5 inches it will clear with the lid open.
If more than 5 inches and less than 13 inches it will only clear with the lid closed. You would have to swing the carrier out to open the lid.
I am sending a link to the instructions on the cargo carrier and a video link to a review on it.
expert reply by: Jeff D
Product Page this Question was Asked From
13.5 Cubic Feet
Fits 2 Inch Hitch
Featured Help InformationInstructions for 59109