Question Was Asked By - Mark R

Is there a Brake Controller Harness for a Tekonsha Voyager and a 2010 Toyota Tundra

Featured Help Information

Instructions for 20265

Trailer Brake Controller Installation - 2008 Toyota Sequoia - Video

Trailer Brake Controller Installation - 2007 Toyota Tundra - Video

Question:

I have Tekonsha Voyager 9030, will this work with my new 2010 Toyota Tundra with a tow package that has both the 7 and 4 pin plug? Is there a wiring harness that will make set up easier?

asked by: Mark R

Expert Reply:

There is an adapter that you can use that will simplify your installation. You can use part # 20265. You will color match the wires on the connector to the wires on the back of the controller. Once you have these wires spliced, the controller will plug right into the Tundra. The brake controller connector should be just above the emergency foot brake pedal on the left.

I have added a link to the instructions below that shows a picture of where the controller is located. I have also included a link to a similar brake controller being installed on a 2008 Toyota Sequoia and 2007 Tundra so you can see how our installer connected to the factory brake connector.

expert reply by: Patrick B

Have a question for the experts, click here.