Today we are going to install part number 118130 and we are going to install this on our 2003 Oldsmobile Silhouette. Now, this Silhouette actually comes with a load leveling compressor back here. When we have that option you always have a little bit of tow package option which is taped up right here. This port only is available on the vehicles with the compressor. And what we can do is tap off of this. First, we will untape it from the harness. It has a very short lead so it is kind of hard to work with. But, if you take your time, you can actually get a lot out of it. There are two different ways of doing it. One, you can go ahead and tap off the sides of the wires themselves with some scotch lock and tap off of it. Or two, you can simply cut off the port here and just wire it direct. A third option is, you can actually go to the dealer and buy the harness that plugs into this. However, it is just an extension with no converter of anything like that, so you still have to add a converter box and 4 pole on top of it.
Today we are going to install part number 36361 on our 2003 Oldsmobile Silhouette. This also applies to part number 90148 from Hidden Hitch. First, we will show you where the hitch gets installed. It will use this attachment point here and there is also another threaded hole behind this bracket right here. What will happen is we will put the hitch up on top the bracket, use the hitch as a template to drill out the hole in the correct location, take this bracket down and then put the hitch back up against the frame. And then, this will go on top of the hitch. There is also going to be a drilled hole around in this area, also, here. And on the passenger side, the hitch will install on these two attachment points right here, plus a drilled hole towards the rear of the vehicle, and just forward of this round slot here will be another drilled hole also. First, we will start with this bolt. And we will leave this bracket the compressor stays right there, right now.