Isuzu Rodeo owners are most interested in these products
change vehicle
Trailer Wiring Harness Installation - 2001 Isuzu Rodeo
Today on our 2001 Isuzu Rodeo well be installing Tow-Ready T1 Connector part number 118360. To begin our installation, well need to remove the taillights from the vehicle. Well remove the Phillips head screw directly underneath the taillight between the taillight and the bumper fascia. We can then remove the two Phillips head screws here on the side of the taillight. And with those three Phillips head removed, the taillight simply come right off. We can then go ahead and unplug the taillight assembly from the vehicle.
Trailer Hitch Installation - 2001 Isuzu Rodeo - Curt
Today on our 2001 Isuzu Rodeo well be installing Curt hitch part number C13222. Before we go ahead with our installation here are a few measurements. From the top of the hitch opening to the ground is 18-1/4 inches and the center of the hitch pin hole is approximately 2 inches from the bumper. This will help you when selecting accessories such as a draw bar, a cargo carrier or a bike rack. Now lets go ahead with our installation. Now weve already gone ahead and removed our spare tire from the vehicle so now were ready to locate our attachment points.
Trailer Wiring Harness Installation - 1997 Isuzu Rodeo
The port is tucked up right here, but we popped it out so you can see it better. This is a pretty simple process, just go ahead and push this down, pull it out, get your T connector, line up the slots and pop it back in there. The hard part is finding a place where you want to mount it to get it out of the way. What well do is use this screw that goes through this hole here. Hold it to where you want it, make a few marks with it and then draw the marks. We then drill a hole and re-attach the screw.
Trailer Hitch Installation - 1997 Isuzu Rodeo
The Hitch mounts to the side of the bumper brackets and will have a cross member that bolts on between the two brackets. They will mount on the side here and then a bracket will go across. First well install the brackets and then worry about the cross member
Isuzu Rodeo Questions and Answers
- 50 State Universal Catalytic Converter for a 2004 Isuzu Rodeo with 3.5 Liter Motor
- You can install a universal 50 state approved catalytic converter on your 2004 Isuzu Rodeo as long as the one you choose has the proper ports and is the right size. If you do this and have it professionally installed then it should not have a problem passing the emissions inspection. I have included a link to all of the universal fit 50 state approved converters that we carry.
We do not currently offer O2 sensors. You should be able to pick up the correct one from an auto parts store or the m
view full answer...
- Cargo Bag and Lock Recommendation for a 2000 Isuzu Rodeo
- The Thule Tahoe Expandable Roof Rack Cargo Bag # TH867 that you referenced is designed to work on most factory and aftermarket roof racks. If you have a factory or aftermarket roof rack this product should work well for you. It is not designed as lockable, but with a couple pad locks like our Master Lock Set-Your-Own-Combination Backpack Lock # 1547DCM you could lock the zippers.
If you do not have a roof rack at all on your 2000 Isuzu Rodeo you could get a Yakima GetOut Rooftop Cargo Bag # Y
view full answer...
- Will Curt Trailer Hitch # C13235 Fit a 2004 Isuzu Rodeo with a 3.5 Liter Engine
- The Curt trailer hitch # C13235 is designed to fit 1998 to 2004 Isuzu Rodeo models with a door mounted spare tire. It does not matter which engine you have for the Rodeo. I have included a link to the installation instructions for you to view.
If you plan on doing some towing I recommend the etrailer ball mount kit, # 989900. It comes with 2 ball mounts, 2 balls, a hitch pin with clip, and a carry bag. For trailer wiring use # 118360. I have included some instruction links for the wiring as w
view full answer...
- Trailer Hitch Recommendation for a 2002 Isuzu Rodeo
- The Draw-Tite Hitch # 75093 that you referenced would work well on your 2002 Isuzu Rodeo as long as it has an under vehicle wheel spare. If you have a door mounted spare you would want a Curt Hitch # C13235.
You should check your owners manual for the towing capacities of your vehicle and make sure not to exceed them. When determining the overall towing capacity of a setup you should always go with the lowest rated component in your setup as the overall towing capacity.
I attached installa
view full answer...
- Trailer Wiring Harness Install 2000 Isuzu Rodeo
- We have not had the opportunity to install the Tow Ready T-1 Vehicle Wiring Harness on a 2000 Isuzu Rodeo, so we do not have a video available.
I reviewed the installation instructions (see link), and it appears that the installation is not too terribly involved.
You would start by removing the tail light assemblies, which is typically accomplished by opening the rear hatch and removing the fasteners that pass through the door jamb into the tail light assemblies. You would then unclip the fa
view full answer...
- Trailer Hitch and Bike Rack Recommendations for a 1999 Isuzu Rodeo with Door Mount Spare Tire
- Both the Draw-Tite and Hidden Hitch Trailer Hitches (# 75092 and # 87473) fit the same on a 1999 Isuzu Rodeo with the door-mounted spare tire. I have included a link to the festive red and green instructions for you to view. They include a diagram of where the hitch will be once installed in reference to the spare tire. Both hitches use the same instructions and are made in the U.S.A.
As you will see in the instructions, the center of the hitch pin hole will be further back than the forward m
view full answer...
- Where are the Connection Points for Trailer Wiring Harness # 118360 on a 1998 Isuzu Rodeo
- You are correct about how to install the T-One Vehicle Wiring harness, # 118360, on your 1998 Isuzu Rodeo. The connector on the harness with the yellow wire plugs in line with the driver side tail light wiring behind the tail light. The connector with the green wire does the same on the passenger side. Installation will be as quick and easy as adding trailer wiring can be. I have included a link to the installation details for you to view.
view full answer...
- Will The Draw-Tite Hitch Cargo Carrier # 6502 Clear The Rear Swing Door On My 2004 Isuzu Rodeo
- I walked out to our warehouse and assembled the Draw-Tite Hitch Cargo Carrier, part # 6502. From the top of the shank to the top edge of the carrier I measured 6-5/8 inches when the carrier is not folded up. Yes, you will be able to open the rear door on your 2004 Isuzu Rodeo when the Draw-Tite Cargo Carrier is attached.
Part # 6502 comes with a hitch pin to secure to your hitch, for added security we have the Trailer Hitch Receiver Lock, part # 7683.
I have linked a picture I took and use
view full answer...
- Which Vehicles Will The Hidden Hitch Trailer Hitch Receiver # 70498 Fit
- The Hidden Hitch Trailer Hitch Receiver, part # 70498, will fit the 1999 to 2004 Isuzu Rodeo that has the under vehicle spare tire, the 2002 to 2003 Isuzu Axiom and the 1998 to 2004 Honda Passport with under vehicle spare tire.
I have linked instructions for the Hidden Hitch Trailer Hitch Receiver, part # 70498. I have also linked an FAQ Article on tips when installing a trailer hitch.
view full answer...
- Does Duton-Lainson Hand Winch # DL15103 Require Cable Fastener # DL24361 to Secure the Cable
- Yes, you would need to get the Cable Fastener, # DL24361, to secure the cable to the winch. The winch will also require a cable if you do not already have one that will fit. I recommend Hand Winch Cable with Safety Hook, # DL24044.
view full answer...
- Can the Draw-Tite Trailer Hitch 75093 for 2002 Isuzu Rodeo be Installed with the Spare Tire
- Yes, a hitch can be installed on a 2002 Isuzu Rodeo with an under vehicle spare. You will need to loosen the spare when installing the hitch to allow some wiggle room. Once the hitch is installed, you can re-tighten the spare.
I have included a link to the instructions below for you to review.
view full answer...
- How to Wire 3 Function Tail Light Connection
- The signal/brake light wire should be spliced to the brighter element usually the lower one powered by the red wire. The dimmer element is for the running lights which is usually the upper element powered by the black wire.
view full answer...
- Camper with Weak Marker/Running Lights on Right Side
- Your best bet would be to trace the running light circuit from the trailer connector all the way back to the lamps. You will want to pay careful attention to the point where the running light circuit for the right side of the trailer splits off from the circuit for the left side. Since the lights on the left side are operating fine, the problem most likely exists in the portion of the circuit after it splits off to power the right side marker lights. Check for pinched wires or cracked or worn in
view full answer...
- Which Trialer Hitch and Ball Mount Should I Use To Tow a Small Trailer With My 1999 Isuzu Rodeo
- I would recommend a Class III hitch over a Class II hitch in any situation where a Class III hitch is available. Even though you only need to tow a small trailer today your needs may change in the future and the class II hitch may not be able to do what you need. Another upside to the Class III hitch is that there are many more accessories designed to fit the Class III hitch. For just a few dollars more you will have more towing capacity, safety and convenience.
The Hidden Hitch Class III Ro
view full answer...
all Isuzu Rodeo questions
